Maintenance data (fuel, oil level, etc.)

Weight Weight

DimensionsDimensions and weights


Overall length		181.1 in. (4599 mm)
Overall width		70.2 in. (1782 mm)
Overall height^*		Vehicles with 17-inch tires 55.9 in. (1420 mm) Vehicles with 19-inch tires 56.3 in. (1430 mm)
Wheelbase		108.3 in. (2750 mm)
Tread	Front	61.5 in. (1563 mm)
	Rear	Vehicles with 17-inch tires 62.17 in. (1579 mm) Vehicles with 19-inch tires 62.20 in. (1580 mm)
Vehicle capacity weight (Occupants + luggage)		860 lb. (390 kg)

Unladen vehicle

Seating capacitySeating capacity


Seating capacity		5 (Front 2, Rear 3)

Vehicle identification

Vehicle identification number

Identification Vehicle Vehicle identification number

The vehicle identification number (VIN) is the legal identifier for your vehicle. This is the primary identification number for your Toyota. It is used in registering the ownership of your vehicle.

This number is on the top left of the instrument panel.

This number is also stamped under the right-hand front seat.

This number is also on the Certification Regulation Label.

Identification Engine

Engine Identification number Engine number

The engine number is stamped on the engine block as shown.

Engine


Model	2.0 L 4-cylinder (M20A-FXS)
Type	4-cylinder in line, 4-cycle, gasoline
Bore and stroke	3.17 3.84 in. (80.5 97.6 mm)
Displacement	121.3 cu.in. (1987 cm³)
Valve clearance	Automatic adjustment

Refueling Capacity

Refueling Fuel types

Fuel Capacity

Fuel Type Fuel


Fuel type	Unleaded gasoline only
Octane Rating	87 (Research Octane Number 91) or higher
Fuel tank capacity (Reference)	10.6 gal. (40 L, 8.8 Imp.gal.)

Traction battery (hybrid battery) Specification

Electric motor (traction motor) Specification Electric motor (traction motor)


Type	Permanent magnet synchronous motor
Maximum output	120 kW
Maximum torque	153.4 ft•lbf (208 N•m, 21.2 kgf•m)

Hybrid battery (traction battery) Specification

Battery (traction battery) Specification Hybrid battery (traction battery)


Type	Lithium-ion battery
Voltage	3.7 V/cell
Capacity	51.0 Ah
Quantity	72 cells
Nominal voltage	266.4 V

Oil Engine oil

Engine oil Capacity Lubrication system

Oil capacity (Drain and refill reference^*)


With filter	4.1 qt. (3.9 L, 3.4 Imp. qt.)
Without filter	3.7 qt. (3.5 L, 3.1 Imp. qt.)

The engine oil capacity is a reference quantity to be used when changing the engine oil. When actually adding the engine oil, make sure that the oil level is between the low level mark and refill upper limit mark (Adding engine oil). Warm up and turn off the hybrid system, wait about 5 minutes, and check the oil level on the dipstick.

Engine oil selection

“ Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toyota approved “ Toyota Genuine Motor Oil” or equivalent to satisfy the following grade and viscosity.

Oil grade:

ILSAC GF-6B multigrade engine oil

Recommended viscosity:

SAE 0W-16

SAE 0W-16 is the best choice for good fuel economy and good starting in cold weather.

If SAE 0W-16 is not available, SAE 0W-20 oil may be used. However, it must be replaced with SAE 0W-16 at the next oil change.

Outside temperature

Oil viscosity (0W-16 is explained here as an example):

The 0W in 0W-16 indicates the characteristic of the oil which allows cold startability. Oils with a lower value before the W allow for easier starting of the engine in cold weather.

The 16 in 0W-16 indicates the viscosity characteristic of the oil when the oil is at high temperature. An oil with a higher viscosity (one with a higher value) may be better suited if the vehicle is operated at high speeds, or under extreme load conditions.

How to read oil container label:

API registered mark is added to some oil containers to help you select the oil you should use.

Engine coolant Capacity Cooling system


Capacity^*	Gasoline engine	6.4 qt. (6.1 L, 5.4 Imp. qt.)
Capacity^*	Power control unit	1.7 qt. (1.6 L, 1.4 Imp. qt.)
Coolant type		Use either of the following: “ Toyota Super Long Life Coolant” Similar high-quality ethylene glycol-based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology Do not use plain water alone.

The coolant capacity is the quantity of reference.

If replacement is necessary, contact your Toyota dealer.

Ignition system (spark plug)


Make	DENSO FC16HR-Q8
Gap	0.031 in. (0.8 mm)

Notice:

Iridium-tipped spark plugs

Use only iridium-tipped spark plugs. Do not adjust the spark plug gap.

Electrical system (12-volt Battery)


Open voltage at 68°F (20°C):		12.0 V or higher (Turn the power switch to OFF and turn on the high beam headlights for 30 seconds.) If the voltage is lower than the standard value, charge the battery.
Charging rates (Slow charge)		5 A max.

Fluid Hybrid transmission Hybrid transmission


Fluid capacity^*	3.9 qt. (3.7 L, 3.2 Imp. qt.)
Fluid type	Toyota Genuine e-Transaxle fluid TE

The fluid capacity is the quantity of reference.If replacement is necessary, contact your Toyota dealer.

Notice:

Hybrid transmission fluid type

Using transmission fluid other than the above type may cause abnormal noise or vibration, or ultimately damage the transmission of your vehicle.

Fluid Brake Brakes


Pedal clearance^*1	5.2 in. (132 mm) Min.
Pedal free play	0.04 0.24 in. (1.0 6.0 mm)
Brake pad wear limit	Front 0.06 in. (1.5 mm) Rear 0.08 in. (2.0 mm)
Parking brake indicator^*2	When pushing the parking brake switch for 1 to 2 seconds: turns off When pulling the parking brake switch for 1 to 2 seconds: comes on
Fluid type	FMVSS No.116 DOT 3 or SAE J1703 FMVSS No.116 DOT 4 or SAE J1704

^*1

Minimum pedal clearance when depressed with a force of 67.4 lbf (300 N, 30.6 kgf) while the hybrid system is operating.

When performing the brake pedal inspection, also be sure to check that the brake system warning light is not illuminated when the hybrid system is operating. (If the brake system warning light is illuminated, refer to Brake system warning light (warning buzzer).)

^*2

Make sure to confirm that the brake system warning light (yellow) does not illuminate. (If the brake system warning light illuminates, refer to Brake system warning light (warning buzzer).)

Steering


Free play	Less than 1.2 in. (30 mm)

Wheels Size

Tires Size

Tire inflation pressure Maintenance data Tires and wheels

Vehicles with 17-inch tires


Tire size	195/60R17 90H
Tire inflation pressure (Recommended cold tire inflation pressure)	Front: 36 psi (250 kPa, 2.5 kgf/cm² or bar) Rear: 35 psi (240 kPa, 2.4 kgf/cm² or bar) Spare: None
Wheel size	17 6 1/2J
Wheel nut torque	76 ft•lbf (103 N•m, 10.5 kgf•m)

Vehicles with 19-inch tires


Tire size	195/50R19 88H
Tire inflation pressure (Recommended cold tire inflation pressure)	Front: 35 psi (240 kPa, 2.4 kgf/cm² or bar) Rear: 33 psi (230 kPa, 2.3 kgf/cm² or bar) Spare: None Driving at high speeds (above 100 mph [160 km/h]) (in countries where such speeds are permitted by law): Add 3 psi (20 kPa, 0.2 kgf/cm² or bar) to the front tires and rear tires. Never exceed the maximum cold tire inflation pressure indicated on the tire sidewall.
Wheel size	19 6 1/2J
Wheel nut torque	76 ft•lbf (103 N•m, 10.5 kgf•m)