If a warning message is displayed The multi-information display shows warnings of system malfunctions, incorrectly performed operations, and messages that indicate a need for maintenance. When a message is shown, perform the correction procedure appropriate to the message. If a warning message is displayed again after the appropriate actions have been performed, contact your Toyota dealer. Additionally, if a warning light comes on or flashes at the same time that a warning message is displayed, take the appropriate corrective action for the warning light. (If a warning light turns on or a warning buzzer sounds) Note: Warning messages The warning messages explained below may differ from the actual messages according to operation conditions and vehicle specifications. Warning buzzer In some cases, the buzzer may not be heard due to being in a noisy location or audio sound. If “ EV system stopped Steering Power low” is displayed This message is displayed if the EV system is stopped while driving. When steering wheel operations are heavier than usual, grip the steering wheel firmly and operate it using more force than usual. If “ EV system overheated Output power reduced” is displayed This message may be displayed when driving under severe operating conditions. (For example, when driving up a long steep hill.) Handling method: If your vehicle overheats If “ Shift System Malfunction Shifting Unavailable Drive to a Safe Place and Stop” or “ Shift System Malfunction Driving Unavailable” is displayed There is a malfunction in the shift control system. Have the vehicle inspected by your Toyota dealer immediately. If “ Shift is in N Release Accelerator before shifting” is displayed The accelerator pedal has been depressed when the shift position is in N. Release the accelerator pedal and shift the shift position to D or R. If “ Press brake when vehicle is stopped EV system may overheat” is displayed The message may be displayed when the accelerator pedal is depressed to hold the vehicle while the vehicle is stopped on an incline, etc. The EV system may overheat. Release the accelerator pedal and depress the brake pedal. If “ Auto Power OFF to Conserve Battery” is displayed Power was turned off due to the automatic power off function. Next time when starting the EV system, operate the EV system for approximately 5 minutes to recharge the 12-volt battery. If “ Regenerative Braking Limited Press Brake to Decelerate” is displayed Regenerative braking may be restricted in the following situations. Firmly depress the brake pedal to decelerate the vehicle. When electrical energy cannot be regenerated any more as the traction battery is fully charged When the temperature of the traction battery is extremely high or extremely low When the temperature of the electric motor or power control unit, etc., is extremely high If “ High Power Consumption Power to Climate Temporarily Limited” is displayed Turn off unnecessary electronic equipment to reduce power consumption. Please wait until the power supply returns to normal. If “ Headlight System Malfunction Visit Your Dealer” is displayed The following systems may be malfunctioning. Have the vehicle inspected by your Toyota dealer immediately. The LED headlight system Automatic High Beam If “ Parking Assist Unavailable Sensor Blocked” is displayed A sensor may be covered with water drops, ice, dirt, etc. Remove the water drops, ice, snow, dirt, etc., from the sensor to return the system to normal.Also, due to ice forming on a sensor at low temperatures, a warning message may be displayed or the sensor may not be able to detect an object. Once the ice melts, the system will return to normal.If a sensor is dirty, the position of the dirty sensor will be shown on the display.If an abnormality is displayed even though there are no water drops, ice, snow or dirt, the sensor may be operating abnormally. Have the vehicle inspected by your Toyota dealer. If “ Parking Assist Unavailable Low Visibility See Owner’s Manual” is displayed Indicates one of the following systems is disabled. RCD (Rear Camera Detection) (if equipped) PKSB (Parking Support Brake) (if equipped) Remove any dirt or foreign matter from the rear camera. If “ System Malfunction Visit Your Dealer” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) PDA (Proactive Driving Assist) BSM (Blind Spot Monitor) (if equipped) RCTA (Rear Cross Traffic Alert) (if equipped) Safe Exit Assist (If equipped) Intuitive parking assist (if equipped) PKSB (Parking Support Brake) (if equipped) RCD (Rear Camera Detection) (if equipped) Have the vehicle inspected by your Toyota dealer immediately. If “ System Stopped See Owner’s Manual” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) PDA (Proactive Driving Assist) BSM (Blind Spot Monitor) (if equipped) RCTA (Rear Cross Traffic Alert) (if equipped) Safe Exit Assist (If equipped) Intuitive parking assist (if equipped) PKSB (Parking Support Brake) (if equipped) RCD (Rear Camera Detection) (if equipped) Follow the following correction methods. Check the voltage of the battery Check the sensors that the Toyota Safety Sense 3.0 uses for foreign matter covering them. Remove them if any. (Sensors used by Toyota Safety Sense 3.0) Vehicle with RCD (Rear Camera Detection): Check if the back door is open. Indicates the sensors may not be operating properly. (Situations in which the sensors may not operate properly, BSM (Blind Spot Monitor) - Conditions under which the system may not function correctly, Safe Exit Assist - Conditions under which the system may not function correctly, Intuitive parking assist - Situations in which the system may not operate properly, RCTA (Rear Cross Traffic Alert) - Situations in which the system may not operate properly, RCD (Rear Camera Detection) - Situations in which the system may not operate properly, Parking Support Brake function (static objects front and rear of the vehicle/static objects around the vehicle) - Situations in which the system may not operate properly, Parking Support Brake function (moving vehicles rear of the vehicle) - Situations in which the system may not operate properly, Parking Support Brake function (pedestrians rear of the vehicle) - Situations in which the system may not operate properly) Check the rear bumper around the sensors (To ensure the system can operate properly) used by the BSM (if equipped), RCTA (if equipped) and Safe Exit Assist (if equipped) for foreign matter covering them. Remove them if any. Check the sensors including camera sensors used by the Intuitive parking assist (if equipped) and PKSB (if equipped) for foreign matter covering them. Remove them if any. (System components) When problems are solved and the sensors are operational, this indication may disappear by itself. If “ System Stopped Front Camera Low Visibility See Owner’s Manual” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) PDA (Proactive Driving Assist) Follow the following correction methods. Using the windshield wipers, remove the dirt or foreign matter from the windshield. Using the air conditioning system, defog the windshield. Close the hood, remove any stickers, etc. to clear the obstruction in front of the front camera. If “ System Stopped Front Camera Out of Temperature Range Wait until Normal Temperature” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) PDA (Proactive Driving Assist) Follow the following correction methods. If the front camera is hot, such as after the vehicle is parked in the sun, use the air conditioning system to decrease the temperature around the front camera If a sunshade was used when the vehicle was parked, depending on its type, the sunlight reflected from the surface of the sunshade may cause the temperature of the front camera to become excessively high If the front camera is cold, such after the vehicle is parked in an extremely cold environment, use the air conditioning system to increase the temperature around the front camera If “ System Stopped Front Radar Sensor Blocked Clean Radar Sensor” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control PDA (Proactive Driving Assist) Follow the following correction methods. Check if there is any foreign matter attached to the radar sensor or radar sensor cover and clean them if necessary (To prevent malfunction of the radar sensors) This message may be displayed when driving in an open area with few nearby vehicles or structures, such as a desert, grasslands, suburbs, etc. The message may be cleared by driving the vehicle in an area with structures, vehicles, etc., nearby. If “ System Stopped Front Radar Sensor Out of Temperature Range Wait until Normal Temperature” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control PDA (Proactive Driving Assist) Follow the following correction methods. The temperature of the radar sensor is outside of the operating range. Wait for the temperature to become appropriate. If “ System Stopped Front Radar In Self Calibration See Owner’s Manual” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control PDA (Proactive Driving Assist) Follow the following correction methods. Check if there is any foreign matter attached to the radar sensor or radar sensor cover and clean them if necessary (To prevent malfunction of the radar sensors) The radar sensor may be misaligned and will be adjusted automatically while driving. Continue driving for a while. If “ Cruise Control Unavailable See Owner’s Manual” is displayed Indicates one of the following systems is disabled. Dynamic radar cruise control Cruise control A message is displayed when the driving assist switch is pushed repeatedly. Press the driving assist switch quickly and firmly. If “ Driver Monitor Out of Temperature Range Wait until Normal Temperature” is displayed (if equipped) Indicates one of the following systems is disabled. Driver Monitor The temperature of the driver monitor camera is outside of the operating range. Wait for the temperature to become appropriate. If a message that indicates the need for visiting your Toyota dealer is displayed The system or part shown on the multi-information display is malfunctioning. Have the vehicle inspected by your Toyota dealer immediately. If “ Driver Monitor Unavailable See Owner’s Manual” is displayed (if equipped) The lens of the driver monitor camera may be dirty. When there is dirt on the camera lens, clean it with a dry, soft cloth so as not to damage it. If a message that indicates the need for the rotary shifter operation is displayed To prevent the rotary shifter from being operated incorrectly or the vehicle from moving unexpectedly, a message that requires shifting the shift position may be displayed on the multi-information display. In that case, follow the instruction of the message and shift the shift position. If a message that indicates the need for referring to Owner’s Manual is displayed If any of the following messages are shown on the multi-information display, follow the instructions. “ Battery Low” (If the 12-volt battery is discharged) “ Check Charging System Close Charging Port Lid” (When charging related message is displayed) “ Charging system malfunction” (When charging related message is displayed) “ Charging stopped High energy use” (When charging related message is displayed) If any of the following messages are shown on the multi-information display, it may indicate a malfunction. Have the vehicle inspected by your Toyota dealer immediately. “ Entry & Start System Malfunction” “ Traction battery system malfunction” “ Accelerator system malfunction” “ Plug-in Charging System Malfunction” “ EV system malfunction” “ Shift System Malfunction Apply Parking Brake Securely When Parking See Owner’s Manual” “ Shift System Malfunction See Owner’s Manual” “ Shift System Malfunction Stop in a Safe Place See Owner’s Manual” “ P Switch Malfunction Apply Parking Brake Securely When Parking See Owner’s Manual” “ Shift System Unavailable Apply Parking Brake Securely When Parking See Owner’s Manual” “ Battery Low Shifting Unavailable See Owner’s Manual” If any of the following messages are shown on the multi-information display, it may indicate a malfunction. Immediately stop the vehicle and contact your Toyota dealer. “ Braking Power Low” Notice: If “ High Power Consumption Power to Climate Temporarily Limited” is displayed frequently There is a possible malfunction relating to the charging system or the 12-volt battery may be deteriorating. Have the vehicle inspected by your Toyota dealer. If “ Battery Low” is displayed frequently The 12-volt battery may have deteriorated. As the battery may discharge in this state when left unattended, have the battery inspected by your Toyota dealer. If “ Maintenance Reqd. For Traction Battery At Your Dealer” is shown The traction battery is scheduled to be inspected or replaced. Have the vehicle inspected by your Toyota dealer immediately. Continuing to drive the vehicle without having the traction battery inspected will cause the EV system not to start. If the EV system does not start, contact your Toyota dealer immediately.