Cleaning and protecting the vehicle exterior Perform the following to protect the vehicle and maintain it in prime condition: Cleaning instructions Working from top to bottom, liberally apply water to the vehicle body, wheel wells and underside of the vehicle to remove any dirt and dust. Wash the vehicle body using a sponge or soft cloth, such as a chamois. For hard-to-remove marks, use car wash soap and rinse thoroughly with water. Wipe away any water. Wax the vehicle when the waterproof coating deteriorates. If water does not bead on a clean surface, apply wax when the vehicle body is cool. Note: Self-restoring coat The vehicle body has a self-restoring coating that is resistant to small surface scratches caused in a car wash, etc. The coating lasts for 5 to 8 years from when the vehicle is delivered from the plant. The restoration time differs depending on the depth of the scratch and outside temperature. The restoration time may become shorter when the coating is warmed by applying warm water. Deep scratches caused by keys, coins, etc., cannot be restored. Do not use wax that contain abrasives. Automatic car washes Before washing the vehicle: Fold the mirrors Turn off the power back door (if equipped) Start washing from the front of the vehicle. Make sure to extend the mirrors before driving. Brushes used in automatic car washes may scratch the vehicle surface, parts (wheel, etc.) and harm your vehicle’s paint. Rear spoiler may not be washable in some automatic car washes. There may also be an increased risk of damage to vehicle. When the shift position needs to be held in N, refer to Keeping the shift position in N without activating the automatic P position selection function. High pressure car washes As water may enter the cabin, do not bring the nozzle tip near the gaps around the doors or perimeter of the windows, or spray these areas continuously. Note for a smart key system If the door handle becomes wet while the electronic key is within the effective range, the door may lock and unlock repeatedly. In that case, follow the following correction procedures to wash the vehicle: Place the key in a position 6 ft. (2 m) or more separate from the vehicle while the vehicle is being washed. (Take care to ensure that the key is not stolen.) Set the electronic key to battery-saving mode to disable the smart key system. (Battery-saving function) If the electronic key is inside the vehicle and a door handle becomes wet during a car wash, a buzzer may sound outside the vehicle and “ Key Detected In Vehicle” may be shown on the multi-information display. To turn off the alarm, lock all the doors. Cleaning Aluminum wheels Care Aluminum wheels Wheels and wheel ornaments Remove any dirt immediately by using a neutral detergent. Wash detergent off with water immediately after use. To protect the paint from damage, make sure to observe the following precautions. Do not use acidic, alkaline or abrasive detergent Do not use hard brushes Do not use detergent on the wheels when they are hot, such as after driving or parking in hot weather Care Brake calipers Cleaning Brake calipers Painted brake calipers (if equipped) When using detergent, use neutral detergent. Do not use hard brushes or abrasive cleaners, as they will damage the paint. Do not use detergent on the brake calipers when they are hot. Wash detergent off immediately after use. Brake pads and calipers Rust may form if the vehicle is parked with wet brake pads or disc rotors, causing them to stick. Before parking the vehicle after it is washed, drive slowly and apply the brakes several times to dry the parts. Bumpers Do not scrub with abrasive cleaners. Plated portions If dirt cannot be removed, clean the parts as follows: Use a soft cloth dampened with an approximately 5% solution of neutral detergent and water to clean the dirt off. Wipe the surface with a dry, soft cloth to remove any remaining moisture. To remove oily deposits, use alcohol wet wipes or a similar product. Warning: When washing the vehicle Do not apply water to the inside of the motor compartment. Doing so may cause the electrical components, etc. to catch fire. When cleaning the windshield Set the wiper switch to off.If the wiper switch is in “ AUTO”, the wipers may operate unexpectedly in the following situations, and may result in hands being caught or other serious injuries and cause damage to the wiper blades. Off “ AUTO” When the upper part of the windshield where the raindrop sensor is located is touched by hand When a wet rag or similar is held close to the raindrop sensor If something bumps against the windshield If you directly touch the raindrop sensor body or if something bumps into the raindrop sensor Precaution regarding the front and rear bumpers If the paint of the front or rear bumper is chipped or scratched, the following systems may not function correctly. If this occurs, consult your Toyota dealer. Toyota Safety Sense 3.0 BSM (if equipped) RCTA (if equipped) SEA (if equipped) PKSB (if equipped) Intuitive parking assist (if equipped) Notice: To prevent paint deterioration and corrosion on the body and components (aluminum wheels, etc.) Wash the vehicle immediately in the following cases: After driving near the sea coast After driving on salted roads If coal tar or tree sap is present on the paint surface If dead insects, insect droppings or bird droppings are present on the paint surface After driving in an area contaminated with soot, oily smoke, mine dust, iron powder or chemical substances If the vehicle becomes heavily soiled with dust or mud If liquids such as benzene and gasoline are spilled on the paint surface If the paint is chipped or scratched, have it repaired immediately. To prevent the wheels from corroding, remove any dirt and store in a place with low humidity when storing the wheels. Cleaning the exterior lights Wash carefully. Do not use organic substances or scrub with a hard brush.This may damage the surfaces of the lights. Do not apply wax to the surfaces of the lights.Wax may cause damage to the lenses. When using an automatic car wash Set the wiper switch to off position.If the wiper switch is in “ AUTO”, the wipers may operate and the wiper blades may be damaged. When using a high pressure car wash When washing the vehicle, do not spray the camera or its surrounding area directly with a high pressure washer. Shock applied from high pressure water may cause the device to not operate normally. Do not spray water directly on the radar which is equipped behind the radar sensor cover. Otherwise it may cause the device to be damaged. Do not bring the nozzle tip close to boots (rubber or resin manufactured cover), or connectors or the following parts.The parts may be damaged if they come into contact with high-pressure water. Traction related parts Steering parts Suspension parts Brake parts Keep the cleaning nozzle at least 11.9 in. (30 cm) away from the vehicle body. Otherwise resin section, such as moldings and bumpers, may be deformed and damaged. Also, do not continuously hold the nozzle in the same place. Do not spray the lower part of the windshield continuously. If water enters the air conditioning system intake located near the lower part of the windshield, the air conditioning system may not operate correctly. Do not wash the underside of the vehicle using a high pressure car washer. If water enters the traction battery, the EV system may malfunction. Do not use the washer on the area around the charging port lid. Water could get into the charging inlet and could damage the vehicle. Cleaning aluminum parts When cleaning the hood, do not push hard or put weight on it.The aluminum part may be dented.