Other interior features Sun visorsSun visors To set the visor in the forward position, flip it down. To set the visor in the side position, flip down, unhook, and swing it to the side. To use the side extender (if equipped), place the visor in the side position, then slide it backward. Vanity mirrors Vanity lights Vanity lights Mirrors Vanity mirrors Lights Vanity lights Vanity mirrors Vanity lights Vanity mirrors Slide the cover to open. The light turns on when the cover is opened. Note: Vanity lights If the vanity lights remain on when the power switch is turned off, the lights will go off automatically after 20 minutes. Notice: To prevent 12-volt battery discharge Do not leave the vanity lights on for extended periods while the EV system is off. Power outletsPower outlet Please use a power supply for electronic goods that use less than 12 VDC /10 A (power consumption of 120 W). When using electronic goods, make sure that the power consumption of all the connected power outlets is less than 120 W. Open the lid. Note: The power outlet can be used when The power switch is in ACC or ON. When stopping the EV system Disconnect electrical devices with charging functions, such as mobile battery packs.If such devices are left connected, the EV system may not stop normally. Notice: When power outlet is not in use To avoid damaging the power outlet, close the power outlet lid when the power outlet is not in use.Foreign objects or liquids that enter the power outlet may cause a short circuit. To prevent 12-volt battery discharge Do not use the power outlet longer than necessary when the EV system is off. To prevent incorrect operation of the vehicle When turning the power switch off, make sure to disconnect accessories designed for charging, such as portable chargers, power banks, etc. from the power outlets. If such an accessory is left connected, the following may occur: The doors will not be able to be locked. The opening screen will be displayed on the multi-information display. The interior lights, instrument panel lights, etc. will illuminate. USB charging portsUSB Type-C charging ports The USB Type-C charging ports are used to supply 3 A of electricity at 5 V to external devices.The USB Type-C charging ports are for charging only. They are not designed for data transfer or other purposes.Depending on the external device, it may not charge properly. Refer to the manual included with the device before using a USB charging port. Refer to “ MULTIMEDIA OWNER’S MANUAL” for USB Type-A information. Using the USB Type-C charging ports Center console Rear (if equipped) Note: The USB Type-C charging ports can be used when The power switch is in ACC or ON. Situations in which the USB Type-C charging ports may not operate correctly If a device which consumes more than 3 A at 5 V is connected If a device designed to communicate with a personal computer, such as a USB memory device, is connected If the connected external device is turned off (depending on device) If the temperature inside the vehicle is high, such as after the vehicle has been parked in the sun About connected external devices Depending on the connected external device, charging may occasionally be suspended and then start again. This is not a malfunction. Notice: To prevent damage to the USB Type-C charging ports Do not insert foreign objects into the ports. Do not spill water or other liquids into the ports. Do not apply excessive force to or impact the USB Type-C charging ports. Do not disassemble or modify the USB Type-C charging ports. To prevent damage to external devices Do not leave external devices in the vehicle. The temperature inside the vehicle may become high, resulting in damage to an external device. Do not push down on or apply unnecessary force to an external device or the cable of an external device while it is connected. To prevent 12-volt battery discharge Do not use the USB Type-C charging ports for a long period of time with the EV system stopped. Wireless chargerWireless charger (if equipped) A portable device can be charged by just placing Qi standard wireless charge compatible portable devices according to the Wireless Power Consortium, such as smartphones and mobile batteries, etc., on the charge area. The compatible portable devices can be found on the following Wireless Power Consortium website. https://www.wirelesspowerconsortium.com/ This function cannot be used with portable devices that are larger than the charging tray. Also, depending on the portable device, it may not operate as normal. Please read the operation manual for portable devices to be used. The “ Qi” symbol The “ Qi” symbol is a trademark of the Wireless Power Consortium. Name for all parts Charging tray Charging area* Operation indicator light *Portable devices and wireless chargers contain charging coils. The charging coil in the wireless charger can be moved within the charge area near the center of the charging tray. If the charging coil inside a portable device is detected in the charge area, the charging coil inside the wireless charger will move toward it and start charging. If the charging coil inside a portable device moves outside of the charge area, charging will automatically stop.If 2 or more portable devices are placed on the charging tray, their charging coils may not be properly detected and they may not be charged. Using the wireless charger Open the lid. Place the portable device on the charging tray. Place the charging side of the portable device down with the center of the device in the center of the charge area. Depending on the portable device, the charging coil may not be located in the center of the device. In this case, place the portable device so that its charging coil is in the center of the charge area. When charging, the operation indicator light (orange) comes on. If charging is not occurring, try placing the portable device as close to the center of the charging area as possible. If charging is not performed, the operation indicator light will slowly illuminate in green and orange alternatively and a sound of charging coil operation may be heard repeatedly. When charging is complete, the operation indicator light (green) comes on. Recharging function When charging is complete and after a fixed time in the charge suspension state, charging restarts. When a portable device is moved significantly in the charge area, the charging coil is disconnected and charging is stopped momentarily. However, if there is a charging coil in the charge area, the charging coil inside the wireless charger will move toward it and then charging restarts. Rapid charging function The following portable devices support rapid charging. Portable devices compliant with WPC Ver1.2.4 and compatible with rapid charging iPhone’s with an iOS version that supports 7.5 W charging (iPhone 8 and later models) When a portable device that supports rapid charging is charged, charging automatically switches to the rapid charging function. Lighting conditions of operation indicator light
Operation indicator light Conditions
Charging tray side Multimedia system screen side
Turning off Disappear When the Wireless charger power supply is off
Green (comes on) Gray On Standby (charging possible state)*1
When charging is complete*2
Orange (comes on) Blue When placing the portable device on the charging area (detecting the portable device)
Charging
*1Charging power will not be output during standby. A metallic object will not be heated, if it is placed on the charging tray in this state. *2Depending on the portable device, there are cases where the operation indicator light will continue being lit up orange even after the charging is complete. The wireless charger is not working properly The following are situations in which the wireless charger does not work properly and how to deal with the possible causes.
Operation indicator light Multimedia system screen Suspected causes/Handling method
Orange (Flashing repeatedly once every second) Gray Wireless charger and smart key communication failure If the EV system is turned on, off and then restart the EV system. If the power switch is in ACC, start the EV system. (Starting the EV system)
Green (Flashing repeatedly once every second) Disappear Wireless charger and multimedia system communication failure If the EV system is turned on, off and then restart the EV system. If the power switch is in ACC, start the EV system. (Starting the EV system)
Green (comes on) Blue AM radio stations are being automatically selected Wait until the system has completed the automatic selection of AM radio stations. In the case that automatic selection cannot be completed, stop automatic selection.
The smart key system is detecting the key Please wait until the key detection is complete.
Orange (Repeatedly flashes 3 times continuously) Gray Foreign substance detection:A metallic foreign substance is in the charge area, and so the abnormal heating prevention function of the metallic foreign substance operated Remove the foreign substance from the charge area.
Portable device misaligned: The charging coil in the portable device moved outside of the charge area, and so the abnormal heating prevention function operated.
Orange (Repeatedly flashes 4 times continuously) Gray Safety shutdown resulting when the temperature within the wireless charger exceeded the set value Stop charging, remove the portable device from the charging tray, wait for the temperature to drop, and then start charging again.
Note: The wireless charger can be operated when The power switch is in ACC or ON. Portable devices that can be charged Portable devices compatible with the Qi wireless charging standard can be charged by the wireless charger. However, compatibility with portable devices that comply with Qi Ver. 1.0, 1.2.4 and later versions is not guaranteed. The wireless charger is designed to supply low power electricity (5 W or less) to a cellular phone, smartphone, or other portable device. Failure to do so may result in the possibility of fire, However, portable devices, such as the following, can be charged with more than 5 W. 7.5 W charging compatible iPhones can be charged at 7.5 W or less. Portable devices which conform to WPC Ver 1.2.4 (Extended Power profile) can be charged at 10 W or less. When covers and accessories are attached to portable devices Do not charge in situations where cover and accessories not able to handle Qi are attached to the portable device. Depending on the type of cover (including for certain genuine manufacturer parts) and accessory, it may not be possible to charge.When charging is not performed even with the portable device placed on the charge area, remove the cover and accessories. AM radio cooperation function during charging During charging, if noise occurs when listening to the AM radio, the charging frequency is automatically changed to reduce the noise. When automatically seeking AM radio stations, charging will be suspended to prevent charging noise from being detected as a radio station. Charging will resume automatically. Charging precautions If the electronic key cannot be detected in the cabin, charging cannot be performed. When a door is opened and closed, charging may be temporarily suspended. While charging, the wireless charger and the portable device will become warm. This is not a malfunction. If a portable device becomes warm while charging and charging stops due to the protection function of the portable device, wait until the portable device cools down and charge it again. Depending on usage of the portable device, it may not be fully charged. This is not a malfunction. Important points of the wireless charger If the electronic key cannot be detected within the vehicle interior, charging can not be done. When the door is opened and closed, charging may be temporarily suspended. When charging, the wireless charging device and portable device will get warmer, however this is not a malfunction. When a portable device gets warm while charging may stop due to the protection function on the portable device side. In this case, when the temperature of the portable drops significantly, charge again.The fan may start operating to lower the temperature inside the wireless charger, however this is not a malfunction. Sound generated during operation When the power supply switch is turned on or while a portable device is being identified, operation sounds may be heard. This is not a malfunction. Cleaning the wireless charger Water in the vehicle Trademark information iPhone is a trademark of Apple Inc., registered in the U.S. and other countries. Galaxy is a trademark or registered trademark of Samsung Electronics Co.,Ltd. Certification Wireless charger Warning: Caution while driving When charging a portable device, for safety reasons, the driver should not operate the main part of the portable device while driving. Caution while in motion Do not charge lightweight devices such as wireless headphones while in motion. These devices are very light and may be ejected from the charging tray, which may lead to unforeseen accidents. Caution regarding interference with electronic devices People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverters, as well as any other electrical medical device, should consult their physician about the usage of the wireless charger. To prevent malfunctions or burns Observe the following precautions. Failure to do so may result in a equipment failure and damage, catch fire, burns due to overheat or electric shock. Do not insert any metallic objects between the charge area and the portable device while charging Do not attach an aluminum sticker or other metallic object to the charge area Do not attach an aluminum sticker or other metallic object to the side of the portable device (or to its case or cover) that touches the charge area Do not use the charging tray as a small storage space Do not subject to a strong force or impact Do not disassemble, modify or remove Do not charge devices other than specified portable devices Keep away from magnetic items Do not charge devices if the charge area is covered in dust Do not cover with a cloth or similar material Notice: Situations in which the function may not operate normally Devices may not be charged normally in the following situations. The portable device is fully charged The portable device is being charged with a cable connected There is foreign matter between the charge area and portable device Charging has caused the portable device to heat up The temperature around the charging tray is 95°F (35°C) or higher, such as in extreme heat The portable device is placed with its charging side facing up The portable device is placed in an area misaligned from the charge area The portable device is larger than the charging tray The small portable device such as foldable type is placed in an area misaligned from the charge area The camera lens protrudes 0.12 in. (3 mm) or more from the surface of the portal device The vehicle is in an area where strong electrical waves or noise are emitted, such as near a television tower, power plant, gasoline station, broadcasting station, large display, airport, etc. Any of the following objects that is protrudes 0.12 in. (3 mm) or thicker is stuck or installed between the charging side of the portable device and the charge area. Thick cases or covers A case or cover attached with an uneven or tilted surface, so that the charging side is not flat Thick decorations Accessories, such as finger rings, straps, etc. When the portable device is in contact with, or is covered by any of the following metallic objects: A card that has metal on it, such as aluminum foil, etc. A pack of cigarettes that includes aluminum foil A wallet or bag that is made of metal Coins A heating pad CDs, DVDs or other media A metal accessory A case or cover made of metal Casing which has magnet in it on the charging side of the portable device Electric wave type wireless remote controls are being used nearby The electronic key is not inside the vehicle If a portable device with a built in S-pen (Galaxy “ Note” series, etc.) is placed on the tray with the S-Pen inserted 2 or more portable devices are placed on the charging tray at the same time If charging is abnormal or the operation indicator light continues to flash for any other reason, the wireless charger may be malfunctioning. Contact your Toyota dealer. To prevent malfunctions and data corruptions When charging, bringing a credit, or other magnetic card, or magnetic storage media close to the charge area may clear any stored data due to magnetic influence. Also, do not bring a wristwatch or other precision instrument close to the charge area since doing so may cause it to malfunction. Do not charge with a non-contact IC card such as a transportation system IC card inserted between the charging side of a portable device and the charge area. The IC chip may become extremely hot and damage the portable device or IC card. Be especially careful not to charge a portable device inside a case or cover with a non-contact IC card attached. Do not leave portable devices inside the vehicle. The inside of the vehicle can become hot in extreme heat, which could cause a malfunction. If the smartphone OS has been updated If the smartphone OS has been updated to a newer version, its charging specifications may have changed significantly.For details, check the information on the manufacturer’s website. To prevent 12-volt battery discharge Do not use the wireless charger for a long period of time when the EV system is stopped. ArmrestArmrest Fold down the armrest for use. Notice: To prevent damage to the armrest Do not apply too much load on the armrest. Hooks Coat hooks Coat hooksCoat hooks The coat hooks are provided with the rear assist grips. Warning: Items that must not be hanged on the hook Do not hang coat hangers or other hard or sharp objects on the hook. If the SRS curtain shield airbags deploy, these items may become projectiles, causing death or serious injury. Assist gripsAssist grips An assist grip installed on the ceiling can be used to support your body while sitting on the seat. Warning: Assist grips Do not use the assist grip when getting in or out of the vehicle or rising from your seat. Notice: To prevent damage to the assist grip Do not hang any heavy object or put a heavy load on the assist grip.