Air conditioning filter The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removal method Turn the power switch off. Confirm that the charging connector is not connected. Also, do not use the Remote Air Conditioning System during the procedure. Open the front passenger’s door. By keeping the door open, unexpected operation of the Remote Air Conditioning System can be prevent. (Remote Air Conditioning System) Open the glove box and slide off the damper. Push in each side of the glove box to disconnect the claws, and then slowly and fully open the glove box while supporting it. With the glove box fully open, slightly lift up the glove box and pull toward the seat to detach the bottom of the glove box. Do not use excessive force if the glove box does not detach when lightly pulled. Instead, pull toward the seat while slightly adjusting the height of the glove box. Unlock the filter cover ( ), pull the filter cover out of the claws ( ), and remove the filter cover. Remove the filter case. Remove the air conditioning filter from the filter case and replace it with a new one. The “ UP” marks shown on the filter should be pointing up. When installing, reverse the steps listed. Note: Checking interval Inspect and replace the air conditioning filter according to the maintenance schedule. In dusty areas or areas with heavy traffic flow, early replacement may be required. (For scheduled maintenance information, please refer to the “ Owner’s Manual Supplement” or “ Scheduled Maintenance”.) If air flow from the vents decreases dramatically The filter may be clogged. Check the filter and replace if necessary. Warning: When replacing the air conditioning filter Observe the following precautions. Failure to do so may result in the air conditioning system operating during the procedure, possibly resulting in injury. Check that the charging connector is not connected The air conditioning may operate due to the “ Climate Prep” or “ Climate preparation” (Air conditioning-linked setting (“Climate Prep” or “Climate preparation”)) setting. Do not use the Remote Air Conditioning System Notice: When using the air conditioning system Make sure that a filter is always installed. Using the air conditioning system without a filter may cause damage to the system. When removing the glove box Always follow the specified procedure to remove the glove box (Removal method). If the glove box is removed without following the specified procedure, the hinge of the glove box may become damaged. To prevent damage to the filter cover When moving the filter cover in the direction of arrow to release the fitting, pay attention not to apply excessive force to the claws. Otherwise, the claws may be damaged.