Power back window The power back window can be opened and closed using the switch or key. Warning: Caution while driving Keep the back window closed. This not only keeps personal belongings from being thrown out, but also prevents exhaust gases from entering the vehicle. Opening and closing procedures From inside the vehicle Opening (push and hold) Closing (pull and hold) From outside the vehicle Opening (push and hold) Closing (push and hold) This operation can only be performed when the electronic key is within the detection range. Note: The power back window can be operated from inside the vehicle when The power switch is in ON. The power back window can be opened when the rear window wiper is working, but the wiper stops working until the window is closed again. If the power back window is not fully closed, the rear window wiper, washer, and defogger will not work. If the back door is not fully closed, the power back window cannot be opened using the switch located in the cabin. (It is still possible to close the window.) If the back door is opened while the power back window is opening or closing, window operation will stop. The power back window can be operated from outside the vehicle when The power switch is off. The back door is closed. Operating the power back window from inside the vehicle after turning the hybrid system off The power back window can be operated for approximately 45 seconds even after the power switch is turned to ACC or turned off. It cannot, however, be operated once either front door is opened. Jam protection function If an object becomes caught between the window and the window frame, window travel is stopped and the window is opened slightly. When the power back window does not close normally If the jam protection function is operating abnormally and a window cannot be closed, perform the following operations using the power back window switch. After stopping the vehicle, the window can be closed by holding the power back window switch in the one-touch closing position while the power switch is turned to IGNITION ON. If the window still cannot be closed even by carrying out the operation explained above, initialize the function by performing the following procedure. Hold the power back window switch in the one-touch closing position. Continue holding the switch for a further 6 seconds after the window has closed. Hold the power back window switch in the one-touch opening position. Continue holding the switch for a further 2 seconds after the window has opened completely. Hold the power back window switch in the one-touch closing position once again. Continue holding the switch for a further 2 seconds after the window has closed. If you release the switch while the window is moving, start again from the beginning. If the window continues to close but then re-open slightly even after performing the above procedure correctly, have the vehicle inspected by your Toyota dealer. Customization Some functions can be customized. (Power windows and moon roof* (, )) Power back window open warning buzzer A buzzer sounds and a message is shown on the multi-information display in the instrument cluster when the power switch is turned off and the driver’s door is opened with the power back window open. Warning: Observe the following precautions.Failure to do so may result in death or serious injury. Caution while driving Keep the back door and back window closed while driving. If the back door or the back window is left open, the back door may hit nearby objects while driving or luggage may be unexpectedly thrown out, causing an accident. In addition, exhaust gases may enter the vehicle, causing death or a serious health hazard. Make sure to close the back door and back window before driving. Child safety Power back window Closing the back window The driver is responsible for all the power back window operations, including the operation for the passengers. In order to prevent accidental operation, especially by a child, do not let a child operate the power back window. It is possible for children and other passengers to have body parts caught in the power back window. Check to make sure that all passengers do not have any part of their body in a position where it could be caught when a window is being operated. When using the key or mechanical key and operating the power windows, operate the power window after checking to make sure that there is no possibility of any passenger having any of their body parts caught in the window. Also do not let a child operate window by the key or mechanical key. It is possible for children and other passengers to get caught in the power window. When exiting the vehicle, turn the power switch off, carry the key and exit the vehicle along with the child. There may be accidental operation, due to mischief, etc., that may possibly lead to an accident. Jam protection function Never use any part of your body to intentionally activate the jam protection function. The jam protection function may not work if something gets caught just before the window fully closes.