Other interior features

USB charging portUSB charging port

The USB charging port are used to supply 2.1 A of electricity at 5 V to external devices.The USB charging port are for charging only. They are not designed for data transfer or other purposes.Depending on the external device, it may not charge properly. Refer to the manual included with the device before using a USB charging port.

Using the USB charging port

Lift the lid while pulling up the knob.

Note:

The USB charging port can be used when

The power switch is in ACC or ON.

Situations in which the USB charging port may not operate correctly

If a device which consumes more than 2.1 A at 5 V is connected

If a device designed to communicate with a personal computer, such as a USB memory device, is connected

If the connected external device is turned off (depending on device)

If the temperature inside the vehicle is high, such as after the vehicle has been parked in the sun

About connected external device

Depending on the connected external device, charging may occasionally be suspended and then start again. This is not a malfunction.

Notice:

To prevent damage to the USB charging port

Do not insert foreign objects into the port.

Do not spill water or other liquids into the port.

Do not apply excessive force to or impact the USB charging port.

Do not disassemble or modify the USB charging port.

To prevent damage to external devices

Do not leave external devices in the vehicle. The temperature inside the vehicle may become high, resulting in damage to an external device.

Do not push down on or apply unnecessary force to an external device or the cable of an external device while it is connected.

To prevent 12-volt battery discharge

Do not use the USB charging port for a long period of time with the hybrid system stopped.

Power outletPower outlet

The power outlet can be used for 12 V accessories that run on less than 10 A.

Lift the lid while pulling up the knob and open the power outlet lid.

Note:

The power outlet can be used when

The power switch is in ACC or ON.

When stopping the hybrid system

Disconnect electrical devices with charging functions, such as mobile battery packs.If such devices are left connected, the hybrid system may not stop normally.

Notice:

To prevent the fuse from being blown

Do not use an accessory that uses more than 12 V 10 A.

To avoid damaging the power outlet

Close the power outlet lid when the power outlet is not in use. Foreign objects or liquids that enter the power outlet may cause a short circuit.

To prevent 12-volt battery discharged

Do not use the power outlet longer than necessary when the hybrid system is off.

Wireless chargerWireless charger (if equipped)

A portable device, such as a smartphone or mobile battery, can be charged by just placing it on the charging area, provided the device is compatible with the Qi wireless charging standard created by the Wireless Power Consortium.

The wireless charger cannot be used with a portable device that is larger than the charging area. Additionally, depending on the portable device, the wireless charger may not operate properly. Refer to the operation manual of the portable device.

The “Qi” symbol

The “Qi” symbol is a trademark of the Wireless Power Consortium.

Name for all parts

Power supply switch

Operation indicator light

Charge area

Using the wireless charger

Press the power supply switch of the wireless charger.

Pressing the switch again turns the wireless charger off.When turned on, the operation indicator light (green) comes on. When the power switch is turned off, the on/off state of the wireless charger will be memorized.

Place a portable device on the charging area with its charging surface facing down.

While charging, the operation indicator light (orange) will be illuminated.If charging does not begin, move the portable device as close to the center of the charging area as possible.When charging is complete, the operation indicator light (green) will illuminate.

Recharging function

If a certain amount of time has elapsed since charging completed and the portable device has not been moved, the wireless charger will restart charging.

If the portable device is moved within the charging area, charging will stop temporarily then restart.

Operation indicator light status


Operation indicator light	State
Off	The Wireless charger is off
Green (illuminated)	Standby (charging is possible)
Green (illuminated)	Charging is complete^*
Orange (illuminated)	A portable device has been placed on the charging area (identifying the portable device)
Orange (illuminated)	Charging in progress

Depending on the portable device, the operation indicator light may stay illuminated (orange) after charging has completed.

If the operation indicator light blinks

If an error is detected, the operation indicator light will blink (orange). Take the appropriate measures according to the table below.


Operation indicator light	Suspected cause	Measure
Blinks (orange) at a one second interval continuously	Vehicle to charger communication failure.	Contact your Toyota dealer.
Blinks (orange) 3 times repeatedly	A foreign object exists between the portable device and charging area.	Remove the foreign object.
Blinks (orange) 3 times repeatedly	Portable device is not positioned properly on the charging area.	Move the portable device toward the center of the charging area.
Blinks (orange) 4 times repeatedly	The temperature of the wireless charger is excessively high.	Stop charging immediately and continue charging after a while.

Note:

The wireless charger can be operated when

The power switch is in ACC or ON.

Portable devices that can be charged

Portable devices compatible with the Qi wireless charging standard can be charged by the wireless charger. However, compatibility with all devices which meet the Qi wireless charging standard is not guaranteed.

The wireless charger is designed to supply low power electricity (5 W or less) to a cellular phone, smartphone, or other portable device.

If a cover or accessory is attached to the portable device

Do not charge a portable device if a cover or accessory which is not Qi compatible is attached. Depending on the type of cover and/or accessory attached, it may not be possible to charge the portable device. If the portable device is placed on the charging area and does not charge, remove the cover and/or accessories.

If interference is heard in AM radio broadcasts while charging

Turn off the wireless charger and check if the noise is reduced. If noise is reduced, press and hold the power supply switch of the wireless charger for 2 seconds. The frequency of the wireless charger is changed and noise may be reduced. When the frequency is changed, the operation indicator light will blink (orange) 2 times.

Charging precautions

If the electronic key cannot be detected in the cabin, charging cannot be performed. When a door is opened and closed, charging may be temporarily suspended.

While charging, the wireless charger and the portable device will become warm. This is not a malfunction.If a portable device becomes warm while charging and charging stops due to the protection function of the portable device, wait until the portable device cools down and charge it again.

Sound generated during operation

When the power supply switch is turned on or while a portable device is being identified, operation sounds may be heard. This is not a malfunction.

Cleaning the wireless charger

Cleaning and protecting the vehicle interior

Certification for the wireless charger

Warning:

Caution while driving

When charging a portable device while driving, for safety reasons, the driver should not operate the portable device.

Caution regarding interference with electronic devices

People with implantable cardiac pacemakers, cardiac resynchronization therapy pacemakers or implantable cardioverter defibrillators, as well as any other electrical medical device, should consult their physician about the usage of the wireless charger.Operations of the wireless charger may have an affect on medical devices.

To prevent damage or burns

Observe the following precautions. Failure to do so may result in the possibility of fire, equipment failure or damage, or burns due to heat.

Do not put any metallic objects between the charging area and the portable device while charging.

Do not attach metallic objects, such as aluminum stickers, to the charging area.

Do not cover the wireless charger with a cloth or other object while charging.

Do not attempt to charge portable devices which are not compatible with the Qi wireless charging standard.

Do not disassemble, modify or remove the wireless charger.

Do not apply force or impact to the wireless charger.

Notice:

Conditions in which the wireless charger may not operate correctly

In the following situations, the wireless charger may not operate correctly:

When a portable device is fully charged

When there is a foreign object between the charging area and portable device

When a portable device becomes hot while charging

When a portable device is placed on the wireless area with its charging surface facing up

When a portable device is not centered on the charging area

When the vehicle is near a TV tower, electric power plant, gas station, radio station, large display, airport or other facility that generates strong radio waves or electrical noise

When the portable device is in contact with, or is covered by any of the following metallic objects:

Cards to which aluminum foil is attached

Cigarette boxes that have aluminum foil inside

Metallic wallets or bags

Coins

Metal hand warmers

Media such as CDs and DVDs

When wireless keys (that emit radio waves) other than those of your vehicle are being used nearby.

If in situations other than above the wireless charger does not operate properly or the operation indicator light is blinking, the wireless charger may be malfunctioning. Contact your Toyota dealer.

To prevent failure or damage to data

Do not bring magnetic cards, such as a credit card, or magnetic recording media, close to the wireless charger while charging. Otherwise, data may be erased due to the influence of magnetism.Additionally, do not bring precision instruments such as wrist watches, close to the wireless charger, as such objects may malfunction.

Do not leave portable devices in the cabin. The temperature inside the cabin may become high when parked in the sun, and cause damage to the device.

To prevent 12-volt battery discharge

Do not use the wireless charger for a long period of time with the hybrid system stopped.

Sun visorsSun visors

To set the visor in the forward position, flip it down.

To set the visor in the side position, flip down, unhook, and swing it to the side.

To use the side extender, place the visor in the side position, then slide it backward.

Vanity mirrors

Vanity lights

Mirrors Vanity mirrors

Lights Vanity lights Vanity mirrors

Slide the cover to open.

The vanity light turns on.

Note:

To prevent 12-volt battery discharge

If the vanity lights remain on when the power switch is OFF, the lights will go off automatically after 20 minutes.

Notice:

To prevent the 12-volt battery from being discharged

Do not leave the vanity lights on for extended periods while the hybrid system is off.

ArmrestArmrest

Fold down the armrest for use.

Notice:

To prevent damage to the armrest

Do not apply too much load on the armrest.

Assist gripsAssist grips

An assist grip installed on the ceiling can be used to support your body while sitting on the seat.

Warning:

Assist grip

Do not use the assist grip when getting in or out of the vehicle or rising from your seat.

Notice:

To prevent damage to the assist grip

Do not hang any heavy object or put a heavy load on the assist grip.

Hooks Coat hooks

Coat hooksCoat hooks

The coat hooks are provided with the rear assist grips.

Warning:

Items that cannot be hung on the coat hook

Do not hang coat hangers or other hard or sharp objects on the hook. If the SRS curtain shield airbags deploy, these items may become projectiles, causing death or serious injury.