Maintenance data (fuel, oil level, etc.) Weight Weight Total load capacity DimensionsDimensions and weight
Overall length 172.0 in. (4370 mm)
Overall width 70.5 in. (1790 mm)
Overall height* 56.5 in. (1435 mm)
Wheelbase 103.9 in. (2640 mm)
Tread Front 60.2 in. (1530 mm)
Rear 60.2 in. (1530 mm)
Vehicle capacity weight(Occupants + luggage) 860 lb. (390 kg)
*0Unladen vehicles Vehicle identification Vehicle identification number Identification Vehicle Vehicle identification number The vehicle identification number (VIN) is the legal identifier for your vehicle. This is the primary identification number for your Toyota. It is used in registering the ownership of your vehicle. This number is stamped under the right-hand front seat. This number is also stamped on the top left of the instrument panel. This number is also on the Certification Label. Identification Engine Engine Identification number Engine number The engine number is stamped on the engine block as shown. EngineEngine
Model 2.0 L 4-cylinder (M20A-FKS)
Type 4-cylinder in line, 4-cycle, gasoline
Bore and stroke 3.17 3.84 in. (80.5 97.6 mm)
Displacement 121.3 cu. in. (1987 cm3)
Valve clearance Automatic adjustment
Drive belt tension Automatic adjustment
Refueling Fuel types Refueling Capacity Fuel Type Fuel Capacity Fuel
Fuel type Unleaded gasoline only
Octane Rating 87 (Research Octane Number 91) or higher
Fuel tank capacity(Reference) 13.2 gal. (50.0 L, 11.0 Imp. gal.)
Oil Engine oil Engine oil Capacity Lubrication system Oil capacity (Drain and refill [Reference*])
With filter 4.9 qt. (4.6 L, 4.0 Imp. qt.)
Without filter 4.5 qt. (4.3 L, 3.8 Imp. qt.)
*The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick. Engine oil selection “Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toyota approved “Toyota Genuine Motor Oil” or equivalent to satisfy the following grade and viscosity. Oil grade: API SN/RC multigrade engine oil Recommended viscosity: SAE 0W-16 Outside temperature SAE 0W-16 is the best choice for good fuel economy and good starting in cold weather. If SAE 0W-16 is not available, SAE 0W-20 oil may be used. However, it must be replaced with SAE 0W-16 at the next oil change. Oil viscosity (0W-16 is explained here as an example): The 0W in 0W-16 indicates the characteristic of the oil which allows cold startability. Oils with a lower value before the W allow for easier starting of the engine in cold weather. The 16 in 0W-16 indicates the viscosity characteristic of the oil when the oil is at high temperature. An oil with a higher viscosity (one with a higher value) may be better suited if the vehicle is operated at high speeds, or under extreme load conditions. How to read oil container label: API registered marks is added to some oil containers to help you select the oil you should use. Engine coolant Capacity Intercooler coolant Capacity Cooling system
Capacity (Reference) Vehicles with a continuously variable transmission 6.8 qt. (6.4 L, 5.6 Imp. qt.) Vehicles with a manual transmission 6.4 qt. (6.1 L, 5.4 Imp. qt.)
Coolant type Use either of the following: “Toyota Super Long Life Coolant” Similar high-quality ethylene glycol-based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology Do not use plain water alone.
Spark plugIgnition system (spark plug)
Make DENSO FC20HR-Q8
Gap 0.032 in. (0.8 mm)
Notice: Iridium-tipped spark plugs Use only iridium-tipped spark plugs. Do not adjust the spark plug gap. Electrical system (battery)
Open voltage at 68°F (20°C): 12.3 V or higher(Turn the engine switch off and turn on the high beam headlights for 30 seconds.)
Charging rates Quick charge Slow charge 15 A max. 5 A max.
Fluid Continuously variable transmission Continuously variable transmission
Fluid capacity* 9.0 qt. (8.5 L, 7.5 Imp. qt.)
Fluid type Toyota Genuine CVT Fluid FE
*The fluid capacity is a reference quantity.If replacement is necessary, contact your Toyota dealer. Notice: Continuously variable transmission fluid type Using continuously variable transmission fluid other than the above type may cause abnormal noise or vibration, or damage the continuously variable transmission of your vehicle. Fluid Manual transmission Manual transmission
Gear oil capacity (Reference) 1.6 qt. (1.5 L, 1.3 Imp. qt.)
Gear oil type “TOYOTA Genuine Manual Transmission Gear Oil LV GL-4 75W” or equivalent
Notice: Manual transmission gear oil Please be aware that depending on the particular characteristics of the gear oil used or the operating conditions, idle sound, shift feeling and/or fuel efficiency may be different or affected and, in the worst case, damage to the vehicle’s transmission.Toyota recommends to use “TOYOTA Genuine Manual Transmission Gear Oil LV GL-4 75W” to achieve optimal performance. Your Toyota vehicle is filled with “TOYOTA Genuine Manual Transmission Gear Oil LV GL-4 75W” at the factory.Use Toyota approved “TOYOTA Genuine Manual Transmission Gear Oil LV GL-4 75W” or an equivalent oil of matching quality that satisfies the above specifications.Please contact your Toyota dealer for further details. Fluid Clutch Clutch
Pedal free play 0.1 0.6 in. (3 15 mm)
Fluid type FMVSS No.116 DOT 3 or SAE J1703
Fluid Brake Brake Fluid Brakes
Pedal clearance*1 4.1 in. (105 mm) Min.
Pedal free play 0.04 0.24 in. (1 6 mm)
Brake pad wear limit 0.04 in. (1 mm)
Parking brake indicator*2 When pulling the parking brake switch for 1 to 2 seconds: comes on When pushing the parking brake switch for 1 to 2 seconds: turns off
Fluid type FMVSS No.116 DOT 3 or SAE J1703
*1Minimum pedal clearance when depressed with a force of 67.4 lbf (300 N, 30.6 kgf) while the engine is running.When performing the brake pedal inspection, also be sure to check that the brake system warning light is not illuminated when the engine is running. (If the brake system warning light is illuminated, refer to Brake system warning light (warning buzzer).) *2Make sure to confirm that the brake warning light (yellow) does not illuminate. (If the brake warning light illuminates, refer to Brake system warning light.) Steering
Free play Less than 1.2 in. (30 mm)
Wheels Size Tires Size Tire inflation pressure Maintenance data Spare tire Inflation pressure Tires and wheels 15-inch tires
Tire size 195/65R15 91S
Tire inflation pressure(Recommended cold tire inflation pressure) Front tire 38 psi (260 kPa, 2.6 kgf/cm2 or bar) Rear tire 36 psi (250 kPa, 2.5 kgf/cm2 or bar)
Wheel size 15 6 1/2J
Wheel nut torque 76 ft•lbf (103 N•m, 10.5 kgf•m)
16-inch tires
Tire size 205/55R16 91H
Tire inflation pressure(Recommended cold tire inflation pressure) Front tire 35 psi (240 kPa, 2.4 kgf/cm2 or bar) Rear tire 33 psi (230 kPa, 2.3 kgf/cm2 or bar)
Wheel size 16 7J
Wheel nut torque 76 ft•lbf (103 N•m, 10.5 kgf•m)
18-inch tires
Tire size 225/40R18 88V
Tire inflation pressure(Recommended cold tire inflation pressure) Driving under normal conditions Front tire 33 psi (230 kPa, 2.3 kgf/cm2 or bar) Rear tire 30 psi (210 kPa, 2.1 kgf/cm2 or bar) Driving at high speeds (above 100 mph [160 km/h]) (in countries where such speeds are permitted by law) Add 5 psi (30 kPa, 0.3 kgf/cm2 or bar) to the front tires and rear tires. Never exceed the maximum cold tire inflation pressure indicated on the tire sidewall.
Wheel size 18 8J
Wheel nut torque 76 ft•lbf (103 N•m, 10.5 kgf•m)
Compact spare tire (if equipped)
Tire size T125/70D17 98M
Tire inflation pressure(Recommended cold tire inflation pressure) 60 psi (420 kPa, 4.2 kgf/cm2 or bar)
Wheel size 17 4T
Wheel nut torque 76 ft•lbf (103 N•m, 10.5 kgf•m)
Side marker lights Wattage Lights Wattage Personal lights Wattage Vanity lights Wattage Luggage compartment light Wattage License plate lights Wattage Light Wattage Light bulbs
Light bulbs Bulb No. W Type
Exterior Front side marker lights — 5 A
License plate lights — 5 A
Interior Front interior lights/personal lights — 5 A
Vanity lights — 8 A
Rear interior light — 8 B
Luggage compartment light — 5 A
A: Wedge base bulbs (clear) B: Double end bulbs