Light bulbs You may replace the following bulbs yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer. For more information about replacing other light bulbs, contact your Toyota dealer. Preparing for light bulb replacement Check the wattage of the light bulb to be replaced. (Light bulbs) Bulb locations Front Front side marker lights Rear License plate lights Bulbs that need to be replaced by your Toyota dealer Headlights Parking lights Daytime running lights Turn signal lights Front fog lights (if equipped) Tail lights Stop lights Back-up light High mounted stoplight Note: Turn signal lights Replacing light bulbs Tail lights Replacing light bulbs Stop lights Replacing light bulbs Side turn signal lights Replacing light bulbs Rear turn signal lights Replacing light bulbs Parking lights Replacing light bulbs Lights Replacing light bulbs Headlights Replacing light bulbs Front turn signal lights Replacing light bulbs Back-up light Replacing light bulbs Fog lights Replacing light bulbs Front fog lights Replacing light bulbs High mounted stoplight Replacing light bulbs LED light bulbs The lights other than the front side marker lights and license plate lights consist of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. Condensation build-up on the inside of the lens Temporary condensation build-up on the inside of the headlight lens does not indicate a malfunction. Contact your Toyota dealer for more information in the following situations: Large drops of water have built up on the inside of the lens. Water has built up inside the headlight. When replacing light bulbs When replacing light bulbs Replacing light bulbs Front side marker lights Replacing light bulbs Front side marker lights Turn the bulb base counterclockwise. Remove the light bulb. When installing, reverse the steps listed. License plate lights Replacing light bulbs License plate lights Remove the light unit. Insert a flathead screwdriver or similar into the hole next to the light and remove it as shown in the illustration. To prevent damaging the vehicle, wrap the flathead screwdriver with a tape. Turn the bulb base counterclockwise and remove it. Remove the light bulb. When installing, reverse the steps listed. Warning: Replacing light bulbs Turn off the lights. Do not attempt to replace the bulb immediately after turning off the lights. The bulbs become very hot and may cause burns. Do not touch the glass portion of the light bulb with bare hands. When it is unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid getting moisture and oils on the bulb. Also, if the bulb is scratched or dropped, it may blow out or crack. Fully install light bulbs and any parts used to secure them. Failure to do so may result in heat damage, fire, or water entering the light unit. This may damage the lights or cause condensation to build up on the lens. To prevent damage or fire Make sure bulbs are fully seated and locked.