Gauges and meters (4.2-inch display)

Meter display

Engine coolant temperature gauge

Outside temperature

Engine Tachometer

Tachometer

Speedometer

Meter Clock

Clock

Fuel Fuel gauge

Fuel gaugeLocations of gauges and meters

The units of measure may differ depending on the intended destination of the vehicle.

Tachometer

Displays the engine speed in revolutions per minute

Speedometer

Outside temperature

Displays the outside temperature within the range of -40°F (-40°C) to 122°F (50°C)

Clock (Adjusting the clock)

Multi-information display

Presents the driver with a variety of vehicle data (Multi-information display)Displays warning messages if a malfunction occurs (If a warning message is displayed)

Odometer and trip meter display (Odometer and trip meter display)

Shift position indicator (Continuously variable transmission*)

Display change button (Odometer and trip meter display)

Fuel gauge

Displays the quantity of fuel remaining in the tank

Engine coolant temperature gauge

Displays the engine coolant temperature

Note:

Outside temperature display

In the following situations, the correct outside temperature may not be displayed, or the display may take longer than normal to change:

When stopped, or driving at low speeds (less than 16 mph [25 km/h])

When the outside temperature has changed suddenly (at the entrance/exit of a garage, tunnel, etc.)

When “--” or “E” is displayed, the system may be malfunctioning. Take your vehicle to your Toyota dealer.

Liquid crystal display

Warning:

The information display at low temperatures

Allow the interior of the vehicle to warm up before using the liquid crystal information display. At extremely low temperatures, the information display monitor may respond slowly, and display changes may be delayed.

For example, there is a lag between the driver’s shifting and the new gear number appearing on the display. This lag could cause the driver to downshift again, causing rapid and excessive engine braking and possibly an accident resulting in death or injury.

Notice:

To prevent damage to the engine and its components

Do not let the indicator needle of the tachometer enter the red zone, which indicates the maximum engine speed.

The engine may be overheating if the engine coolant temperature gauge is in the red zone (H). In this case, immediately stop the vehicle in a safe place, and check the engine after it has cooled completely. (If your vehicle overheats)

Odometer

Trip metersOdometer and trip meter display

Switches Display change button

Display change button

Odometer and trip meter display Display change button Changing the display

Press the display change button until the desired item is displayed.

Odometer and trip meter display Display items Display items

Odometer

Displays the total distance the vehicle has been driven.

Trip meter A/Trip meter B

Displays the distance the vehicle has been driven since the meter was last reset. Trip meters A and B can be used to record and display different distances independently.

To reset, display the desired trip meter and press and hold the display change button.

Switches Instrument panel light control switches

Meter Instrument panel light control

Instrument panel light control

Brightness control Instrument panel light control Changing the instrument panel light brightness

The brightness of the instrument panel lights can be adjusted.

Brighter

Darker

Note:

Instrument panel light brightness adjustment

The brightness of the instrument panel lights can be adjusted separately for when the tail lights are on and off.

Multi-information display Clock

ClockAdjusting the clock

Clock adjustment

The clocks on the following can be adjusted on the audio system screen.

Multi-information display

Audio system screen

Setting the clock to be adjusted automatically by GPS

Press the “MENU” button.

Select “Setup” on the “Menu” screen.

Select “General” on the “Setup” screen.

Select “Clock”.

Select “Auto Adjust by GPS” to set to on.

Adjusting the clock manually

Press the “MENU” button.

Select “Setup” on the “Menu” screen.

Select “General” on the “Setup” screen.

Select “Clock”.

Select “Auto Adjust by GPS” to set to off.

Adjust the displayed time.

Hour: Select “-” or “+” of “Hours” to adjust the hour.

Minute: Select “-” or “+” of “Minutes” to adjust the minute.

“:00”: Select to set the clock to the beginning of the nearest hour.

e.g.

1:00 to 1:29 1:00

1:30 to 1:59 2:00

Setting the time zone

Press the “MENU” button.

Select “Setup” on the “Menu” screen.

Select “General” on the “Setup” screen.

Select “Clock”.

Select “Time Zone”.

Select the desired time zone.

Premium Audio only:If “Auto” is selected, the time zone is selected automatically by current vehicle position.

Setting daylight saving time

Press the “MENU” button.

Select “Setup” on the “Menu” screen.

Select “General” on the “Setup” screen.

Select “Clock”.

Select “Daylight Saving Time” then on/off/auto^*.

Premium Audio only

Changing the clock between 12-hour/24-hour format

Press the “MENU” button.

Select “Setup” on the “Menu” screen.

Select “General” on the “Setup” screen.

Select “Clock”.

Select “24-Hour Time Format” and then on/off.

When set to off, the clock is displayed in 12 hour time format.

Note:

Clock settings screen

If “Clock : 00” is displayed when is selected on the multi-information display, the system may be malfunctioning. Have the vehicle inspected by your Toyota dealer.