Light bulbs You may replace the following bulbs by yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer. For more information about replacing other light bulbs, contact your Toyota dealer. Preparing for light bulb replacement Check the wattage of the light bulb to be replaced. (Light bulbs (if equipped)) Bulb location Front turn signal/parking lights (bulb type) Lights that need to be replaced by your Toyota dealer Headlights Front turn signal lights (LED type) Daytime running lights Parking lights (LED type) Side marker lights LED accessory lights (if equipped) Fog lights (if equipped) Side turn signal lights (if equipped) Tail lights Stop lights Rear turn signal lights Back-up lights High mounted stoplight License plate lights Outer foot lights (if equipped) Note: LED lights The lights other than the front turn signal lights (bulb type), parking lights (bulb type) and outer foot lights (if equipped) each consist of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. Condensation build-up on the inside of the lens Temporary condensation build-up on the inside of the light lens does not indicate a malfunction. Contact your Toyota dealer for more information in the following situations: Large drops of water have built up on the inside of the lens. Water has built up inside the light. When replacing an electronic component, such as a lights, etc. When replacing an electronic component, such as a lights, etc. Replacing light bulb Front turn signal/parking lights (bulb type) Turn the bulb base counterclockwise. Remove the light bulb. Install a new light bulb then install the bulb base to the light unit by inserting it and turning the bulb base clockwise. Warning: Replacing light bulb Turn off the light. Do not attempt to replace the bulb immediately after turning off the light. The bulb become very hot and may cause burns. Do not touch the glass portion of the light bulb with bare hands. When it is unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid getting moisture and oils on the bulb. Also, if the bulb is scratched or dropped, it may blow out or crack. Fully install light bulb and any parts used to secure it. Failure to do so may result in heat damage, fire, or water entering the light unit. This may damage the light or cause condensation to build up on the lens. Do not attempt to repair or disassemble light bulbs, connectors, electric circuits or component parts.Doing so may result in death or serious injury due to electric shock. To prevent damage or fire Make sure bulb is fully seated and locked. Check the wattage of the bulb before installing to prevent heat damage.