Engine compartment

Components

Fuse boxes (Checking and replacing fuses)

Engine oil filler cap (Adding engine oil)

Engine oil level dipstick (Checking and adding the engine oil)

Brake fluid reservoir (Checking and adding the brake fluid)

Radiator (Checking the radiator and condenser)

Electric cooling fan

Condenser (Checking the radiator and condenser)

Power control unit coolant reservoir (Power control unit coolant reservoir)

Washer fluid tank (Adding the washer fluid)

Engine coolant reservoir (Checking the coolant)

Note:

12-volt battery

Engine oil Checking Checking and adding the engine oil

With the engine at operating temperature and turned off, check the oil level on the dipstick.

Checking the engine oil

Park the vehicle on level ground. After warming up the engine and turning off the hybrid system, wait more than 5 minutes for the oil to drain back into the bottom of the engine.

Holding a rag under the end, pull the dipstick out.

Wipe the dipstick clean.

Reinsert the dipstick fully.

Holding a rag under the end, pull the dipstick out and check the oil level.

Low

Normal

Excessive

The shape of the dipstick may differ depending on the type of vehicle or engine.

Wipe the dipstick and reinsert it fully.

Checking the oil type and preparing the items needed

Make sure to check the oil type and prepare the items needed before adding oil.

Engine oil selection

Oil quantity (Low Full)

1.6 qt. (1.5 L, 1.3 Imp. qt.)

Item

Clean funnel

Adding engine oil

If the oil level is below or near the low level mark, add engine oil of the same type as that already in the engine.

Remove the oil filler cap by turning it counterclockwise.

Add engine oil slowly, checking the dipstick.

Install the oil filler cap by turning it clockwise.

Note:

Engine oil consumption

A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine

If low quality oil or oil of an inappropriate viscosity is used

When driving at high engine speeds or with a heavy load, when towing, or when driving while accelerating or decelerating frequently

When leaving the engine idling for a long time, or when driving frequently through heavy traffic

Warning:

Used engine oil

Used engine oil contains potentially harmful contaminants which may cause skin disorders such as inflammation and skin cancer, so care should be taken to avoid prolonged and repeated contact. To remove used engine oil from your skin, wash thoroughly with soap and water.

Dispose of used oil and filters only in a safe and acceptable manner. Do not dispose of used oil and filters in household trash, in sewers or onto the ground. Call your Toyota dealer, service station or auto parts store for information concerning recycling or disposal.

Do not leave used engine oil within the reach of children.

Notice:

To prevent serious engine damage

Check the oil level on a regular basis.

When replacing the engine oil

Be careful not to spill engine oil on the vehicle components.

Avoid overfilling, or the engine could be damaged.

Check the oil level on the dipstick every time you refill the vehicle.

Be sure the engine oil filler cap is properly tightened.

If oil is spilled on the engine cover

To prevent the engine cover from being damaged, remove any engine oil from the engine cover as soon as possible using a neutral detergent. Do not use an organic solvent such as brake cleaner.

Engine coolant Checking

Cooling system

Coolant Checking Checking the coolant

The coolant level is satisfactory if it is between the “ FULL” and “ LOW” lines on the reservoir when the hybrid system is cold.

Engine coolant reservoir

Reservoir cap

“ FULL” line

“ LOW” line

If the level is on or below the “ LOW” line, add coolant up to the “ FULL” line. (If the engine coolant temperature gauge enters the red zone or “Engine Coolant Temp High Stop in a Safe Place See Owner’s Manual” is shown on the multi-information display)

Power control unit coolant reservoir

Reservoir cap

“ FULL” line

“ LOW” line

If the level is on or below the “ LOW” line, add coolant up to the “ FULL” line. (If “Hybrid System Overheated Output Power Reduced” is shown on the multi-information display)

Note:

Coolant selection

Only use “ Toyota Super Long Life Coolant” or a similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology.U.S.A.:“ Toyota Super Long Life Coolant” is a mixture of 50% coolant and 50% deionized water. (Minimum temperature: -31°F [-35°C])Canada:“ Toyota Super Long Life Coolant” is a mixture of 55% coolant and 45% deionized water. (Minimum temperature: -44°F [-42°C])For more details about coolant, contact your Toyota dealer.

If the coolant level drops within a short time of replenishing

Visually check the radiators, hoses, engine/power control unit coolant reservoir caps, drain cock and water pump.If you cannot find a leak, have your Toyota dealer, test the cap and check for leaks in the cooling system.

Warning:

When the hybrid system is hot

Do not remove the engine/power control unit coolant reservoir caps.

The cooling system may be under pressure and may spray hot coolant if the cap is removed, causing serious injuries, such as burns.

Notice:

When adding coolant

Coolant is neither plain water nor straight antifreeze. The correct mixture of water and antifreeze must be used to provide proper lubrication, corrosion protection and cooling. Be sure to read the antifreeze or coolant label.

If you spill coolant

Be sure to wash it off with water to prevent it from damaging parts or paint.

Radiator

CondenserChecking the radiator and condenser

Check the radiator and condenser, and clear away any foreign objects.If either of the above parts is extremely dirty or you are not sure of their condition, have your vehicle inspected by your Toyota dealer.

Warning:

When the hybrid system is hot

Do not touch the radiator or condenser as they may be hot and cause serious injuries, such as burns.

When the electric cooling fan is operating

Do not touch the engine compartment.

With the power switch in ON, the electric cooling fan may automatically start to run if the air conditioning is on and/or the coolant temperature is high. Be sure the power switch is OFF when working near the electric cooling fan or radiator grille.

Fluid Brake

Brake Fluid Checking and adding the brake fluid

Checking fluid level

The brake fluid level should be between the “ MAX” and “ MIN” lines on the tank.

Adding fluid

Slide and lift up the rubber strip to partly remove it as shown.

Disconnect the claws and remove the service cover.

Remove the reservoir cap.

Add brake fluid slowly while checking the fluid level.

Make sure to check the fluid type and prepare the necessary item.


Fluid type	FMVSS No.116 DOT 3 or SAE J1703 brake fluid FMVSS No.116 DOT 4 or SAE J1704 brake fluid
Item	Clean funnel

Note:

Brake fluid can absorb moisture from the air

Excess moisture in the brake fluid can cause a dangerous loss of braking efficiency. Use only newly opened brake fluid.

Warning:

When filling the reservoir

Take care as brake fluid can harm your hands and eyes and damage painted surfaces.

If fluid gets on your hands or in your eyes, flush the affected area with clean water immediately.

If you still experience discomfort, see a doctor.

Notice:

If the fluid level is low or high

It is normal for the brake fluid level to go down slightly as the brake pads wear out or when the fluid level in the accumulator is high.

If the reservoir needs frequent refilling, there may be a serious problem.

Washer Checking

Washer Low washer fluid warning message

Fluid Washer Adding the washer fluid

If any washer does not work or the warning message appears on the multi-information display, the washer tank may be empty. Add washer fluid.

Warning:

When adding washer fluid

Do not add washer fluid when the hybrid system is hot or operating as washer fluid contains alcohol and may catch fire if spilled on the hybrid system, etc.

Notice:

Do not use any fluid other than washer fluid

Do not use soapy water or engine antifreeze instead of washer fluid.Doing so may cause streaking on the vehicle’s painted surfaces, as well as damaging the pump leading to problems of the washer fluid not spraying.

Diluting washer fluid

Dilute washer fluid with water as necessary.Refer to the freezing temperatures listed on the label of the washer fluid bottle.