Power (ignition) switch (vehicles without smart key system) Power switch Starting the hybrid system Ignition switch (power switch) Starting the hybrid system Hybrid system How to start the hybrid system Hybrid system Starting the hybrid system Starting the hybrid system Pull the parking brake switch to check that the parking brake is set. (Using the manual mode) The parking brake indicator will come on. Check that the shift lever is in P. Firmly depress the brake pedal. Turn the power switch to START to start the hybrid system. If the “ READY” indicator turns on, the hybrid system will operate normally. Continue depressing the brake pedal until the “ READY” indicator is illuminated. Check that the “ READY” indicator is illuminated. The vehicle will not move when the “ READY” indicator is off. Note: If the hybrid system does not start The immobilizer system may not have been deactivated. (Immobilizer system) Contact your Toyota dealer. Steering lock Column lock release When the steering lock cannot be released When starting the hybrid system, the power switch may seem stuck in OFF. To free it, turn the key while turning the steering wheel slightly left and right. When the ambient temperature is low, such as during winter driving conditions When starting the hybrid system, the flashing time of the “ READY” indicator may be long. Leave the vehicle as it is until the “ READY” indicator is steady on, as steady means the vehicle is able to move. When the hybrid battery (traction battery) is extremely cold (below approximately -22°F [-30°C]) under the influence of the outside temperature, it may not be possible to start the hybrid system. In this case, try to start the hybrid system again after the temperature of the hybrid battery increases due to the outside temperature increase etc. Sounds and vibrations specific to a Hybrid Electric Vehicle Sounds and vibrations specific to a Hybrid Electric Vehicle If the “ READY” indicator does not come on In the event that the “ READY” indicator does not come on even after performing the proper procedures for starting the vehicle, contact your Toyota dealer immediately. When “ Check Fuel Cap” is displayed on the multi-information display When “Check Fuel Cap” is displayed on the multi-information display If the hybrid system is malfunctioning Hybrid warning message Warning: When starting the hybrid system Always start the hybrid system while sitting in the driver’s seat. Do not depress the accelerator pedal while starting the hybrid system under any circumstances. Doing so may cause an accident resulting in death or serious injury. Notice: When starting the hybrid system If the hybrid system becomes difficult to start, have your vehicle checked by your Toyota dealer immediately. Power switch Changing the power switch modes Ignition switch (power switch) Changing the power switch modes Changing power switch modes OFF (“ LOCK” position) The steering wheel is locked and the key can be removed. (The key can be removed only when the shift lever is in P.) ACC (“ ACC” position) Some electrical components such as the audio system can be used. ON (“ ON” position) All electrical components can be used. START (“ START” position) For starting the hybrid system. Note: Turning the key from ACC to OFF Shift the shift lever to P. Push in the key and turn it to OFF. Key reminder function A buzzer sounds if the driver’s door is opened while the power switch is in OFF or ACC to remind you to remove the key. Warning: Caution when driving Do not turn the power switch to OFF while driving. If, in an emergency and you must turn the hybrid system off while the vehicle is moving, turn the power switch only to ACC to stop the hybrid system. An accident may result if the hybrid system is stopped while driving. (If your vehicle has to be stopped in an emergency) Notice: To prevent 12-volt battery discharge Do not leave the power switch in ACC or ON for long periods of time without the hybrid system on.