Other interior features Sun visorsSun visors To set the visor in the forward position, flip it down. To set the visor in the side position, flip down, unhook, and swing it to the side. To use the side extender (if equipped), place the visor in the side position, then slide it backward. Vanity mirrors Vanity lights Vanity lights Mirrors Vanity mirrors Lights Vanity lights Vanity mirrors Slide the cover to open. The light turns on when the cover is opened. Note: Automatic light off to prevent battery discharge If the vanity lights remain on when the engine switch is turned to OFF, the lights will go off automatically after 20 minutes. Notice: To prevent battery discharge Do not leave the vanity lights on for extended periods while the engine is off. Power outletsPower outlet The power outlet can be used for the following components: 12 V: Accessories that run on less than 10 A.120 VAC: Accessories that use less than 100 W. 12 V Front Open the lid. Console box (if equipped) Open the console box and open the lid. Rear (if equipped) Open the lid. Luggage compartment (if equipped) Open the lid. 120 VAC (if equipped) Open the lid. Note: The power outlet can be used when 12 V The engine switch is in ACC or ON. 120 VAC The engine switch is in ON. When turning the engine switch off Disconnect electrical devices with charging functions, such as mobile battery packs. If such devices are left connected, the engine switch may not be turned off normally. Notice: To avoid damaging the power outlet Close the power outlet lid when the power outlet is not in use. Foreign objects or liquids that enter the power outlet may cause a short circuit. To prevent the fuse from being blown 12 V Do not use an accessory that uses more than 12 V 10 A. 120 VAC Do not use a 120 VAC appliance that requires more than 100 W. If a 120 VAC appliance that consumes more than 100 W is used, the protection circuit will cut the power supply. To prevent battery discharge Do not use the power outlet longer than necessary when the engine is not running. Appliances that may not operate properly (120 VAC) The following 120 VAC appliances may not operate properly even if their power consumption is under 100 W. Appliances with high initial peak wattage Measuring devices that process precise data Other appliances that require an extremely stable power supply USB charging portsUSB charging ports (if equipped) The USB charging ports are used to supply 2.1 A of electricity at 5 V to external devices.The USB charging ports are for charging only. They are not designed for data transfer or other purposes.Depending on the external device, it may not charge properly. Refer to the manual included with the device before using a USB charging port. Using the USB charging ports Console box Open the console box and open the lid. Rear Open the lid. Note: The USB charging ports can be used when The engine switch is in ACC or ON. Situations in which the USB charging ports may not operate correctly If a device which consumes more than 2.1 A at 5 V is connected If a device designed to communicate with a personal computer, such as a USB memory device, is connected If the connected external device is turned off (depending on device) If the temperature inside the vehicle is high, such as after the vehicle has been parked in the sun About connected external devices Depending on the connected external device, charging may occasionally be suspended and then start again. This is not a malfunction. Notice: To prevent damage to the USB charging ports Do not insert foreign objects into the ports. Do not spill water or other liquids into the ports. When the USB charging ports are not in use, close the lids. If a foreign object or liquid enters a port may cause a short circuit. Do not apply excessive force to or impact the USB charging ports. Do not disassemble or modify the USB charging ports. To prevent damage to external devices Do not leave external devices in the vehicle. The temperature inside the vehicle may become high, resulting in damage to an external device. Do not push down on or apply unnecessary force to an external device or the cable of an external device while it is connected. To prevent battery discharge Do not use the USB charging ports for a long period of time with the engine is off. Wireless chargerWireless charger (if equipped) A portable device can be charged by just placing Qi standard wireless charge compatible portable devices according to the Wireless Power Consortium, such as smartphones and mobile batteries, etc., on the charge area. This function cannot be used with portable devices that are larger than the charging area. Also, depending on the portable device, it may not operate as normal. Please read the operation manual for portable devices to be used. The “ Qi” symbol The “ Qi” symbol is a trademark of the Wireless Power Consortium. Name for all parts Power supply switch Operation indicator light Charge area Using the wireless charger Press the power supply switch of the wireless charger. Switches on and off with each press of the power supply switch. When turned on, the operation indicator light (green) comes on. Even with the engine off, the on/off state of the power supply switch is memorized. Place the charging side of the portable device down. When charging, the operation indicator light (orange) comes on. If charging is not occurring, try placing the portable device as close to the center of the charging area as possible. When charging is complete, the operation indicator light (green) comes on. Recharging function When charging is complete and after a fixed time in the charge suspension state, charging restarts. When the portable device is moved, charging is stopped for a moment and then it restarts. Lighting conditions of operation indicator light

Operation indicator light	Conditions
Turning off	When the Wireless charger power supply is off
Green (comes on)	On Standby (charging possible state)
	When charging is complete*
Orange (comes on)	When placing the portable device on the charging area (detecting the portable device)
	Charging

^*Depending on the portable device, there are cases where the operation indicator light will continue being lit up orange even after the charging is complete. When the operation indicator light flashes When an error occurs, the operation indicator light flashes an orange color.Handle the error based on the following tables. Flashing repeatedly once every second (Orange)

Suspected causes	Handling method
Vehicle to charger communication failure.	Contact your Toyota dealer.

Repeatedly flashes 3 times continuously (Orange)

Suspected causes	Handling method
A foreign substance is between the portable device and charge area.	Remove the foreign substance from between portable device and the charge area.
The portable device is out of sync due to the device being shifted from the center of the charge area.	Place the portable device near the center of the charge area.

Repeatedly flashes 4 times continuously (Orange)

Suspected causes	Handling method
Temperature rising within the wireless charger.	Stop charging at once and start charging again after for a while.

Note: The wireless charger can be operated when The engine switch is in ACC or ON. Usable portable devices Qi standard wireless charge standard can be used on compatible devices.However, not all Qi standard devices and compatibility are guaranteed. Starting with mobile phones and smartphones, it is aimed for low power electrically supplied portable devices of no more than 5W. When covers and accessories are attached to portable devices Do not charge in situations where cover and accessories not able to handle Qi are attached to the portable device. Depending on the type of cover and accessory, it may not be possible to charge. When charging is not performed even with the portable device placed on the charge area, remove the cover and accessories. While charging, noise enters the AM radio Turn off the wireless charger and confirm that the noise has decreased. If the noise decreases, continuously pushing the power supply switch of the wireless charger for 2 seconds, the frequency of the charger can be changed and the noise can be reduced.Also, on that occasion, the operation indicator light will flash orange 2 times. Important points of the wireless charger If the electronic key cannot be detected within the vehicle interior, charging cannot be done. When the door is opened and closed, charging may be temporarily suspended. When charging, the wireless charging device and portable device will get warmer, however this is not a malfunction.When a portable device gets warm while charging, charging may stop due to the protection function on the portable device side. In this case, when the temperature of the portable device drops significantly, charge again. Operation sounds When the power supply is turned on, while searching for the portable device a sound will be produced, however this is not a malfunction. Certification for the wireless charger Warning: Caution while driving When charging a portable device, for safety reasons, the driver should not operate the main part of the portable device while driving. Caution regarding interference with electronic devices People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators, as well as any other electrical medical device, should consult their physician about the usage of the wireless charger. The operations of the wireless charger may have an affect on medical devices. To prevent damage or burns Observe the following precautions.Failure to do so may result in a possibility of equipment failure and damage, catch fire, burns due to overheat. Do not insert any metallic objects between the charging area and the portable device while charging Do not attach stickers, metallic objects, etc., to the charger area or portable device Do not cover with cloth, etc., and charge Do not charge portable devices other than designated Do not attempt to dismantle for disassembly or modifications Do not hit or apply a strong force Notice: Conditions in which the function may not operate correctly In the following conditions, it may not operate correctly The portable device is fully charged There is foreign matter between the charge area and portable device The temperature of the portable device gets higher from charging The charging surface of the portable device is facing up The placement of the portable device is out of alignment with the charge area Near a TV tower, electric power plant, gas station, radio station, large display, airport or other facility that generates strong radio waves or electrical noise When the electronic key is in contact with, or is covered by the following metallic objects Cards to which aluminum foil is attached Cigarette boxes that have aluminum foil inside Metallic wallets or bags Coins Hand warmers made of metal Media such as CDs and DVDs When other wireless keys (that emit radio waves) are being used nearby In addition, excluding the above-mentioned, when the charger does not perform normally or the operation display lamp is flashing continuously, it is considered that the wireless charger is malfunctioning. Contact authorized Toyota dealer. To prevent failure or damage to data Do not bring magnetic cards, such as credit cards, or magnetic recording media, etc., close to the charger while charging, otherwise, data may disappear under the influence of magnetism. Also, do not bring precision instruments such as wrist watches, etc., close to the charger, as such objects may break. Do not leave portable devices in the cabin. The temperature inside the cabin may become high, when under the sun, and cause damage to the device. To prevent battery discharge When the engine is stopped, do not use the wireless charger for a long time. ArmrestArmrest Fold down the armrest for use. Notice: To prevent damage to the armrest Do not apply too much load on the armrest. Assist gripsAssist grips An assist grip installed on the ceiling can be used to support your body while sitting on the seat. Warning: Assist grips Do not use the assist grip when getting in or out of the vehicle or rising from your seat. Notice: To prevent damage to the assist grip Do not hang any heavy object or put a heavy load on the assist grip. Hooks Coat hooks Coat hooksCoat hooks The coat hooks are provided with the rear assist grips. Warning: Items that must not be hanged on the hook Do not hang coat hangers or other hard or sharp objects on the hook. If the SRS curtain shield airbags deploy, these items may become projectiles, causing death or serious injury.