Windshield wipers and washer Operating the lever can switch between automatic operation and manual operation, or can use the washer. Notice: When the windshield is dry Do not use the wipers, as they may damage the windshield. Windshield wipers Position Operating the wiper lever Operating the lever operates the wipers or washer as follows: Windshield wipers Rain-sensing windshield wipers Intermittent windshield wipers ^*1 or ^*2 Off ^*1 or ^*2 Intermittent operation ^*1 or ^*2 Low speed operation ^*1 or ^*2 High speed operation ^*1 or ^*2 Temporary operation ^*1For the U.S.A. ^*2For Canada If equipped, wiper intervals can be adjusted when intermittent operation is selected. Increases the intermittent windshield wiper frequency Decreases the intermittent windshield wiper frequency Washer/wiper dual operation Pulling the lever operates the wipers and washer. The wipers will automatically operate a couple of times after the washer squirts. Rain-sensing windshield wipers ^*1 or ^*2 Off Rain-sensing operation ^*1 or ^*2 Low speed operation ^*1 or ^*2 High speed operation ^*1 or ^*2 Temporary operation ^*1For the U.S.A. ^*2For Canada When “ AUTO” is selected, the wipers will operate automatically when the sensor detects falling rain. The system automatically adjusts wiper timing in accordance with rain volume and vehicle speed. The sensor sensitivity can be adjusted when “ AUTO” is selected. Increases the sensitivity Decreases the sensitivity Washer/wiper dual operation Pulling the lever operates the wipers and washer. The wipers will automatically operate a couple of times after the washer squirts. Note: The windshield wipers and washer can be operated when The engine switch is in ON. Sensor Rain-sensing windshield wipers Raindrop sensor (vehicles with rain-sensing windshield wipers) The raindrop sensor judges the amount of raindrops. If the wiper switch is turned to the “ AUTO” position while the engine switch is in ON, the wipers will operate once to show that “ AUTO” mode is activated. If the wiper sensitivity is adjusted to higher, the wiper may operate once to indicate the change of sensitivity. If the temperature of the raindrop sensor is 185°F (85°C) or higher, or 5°F (-15°C) or lower, the automatic operation may not occur. In this case, operate the wipers in any mode other than “ AUTO”. If no windshield washer fluid sprays Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir. Warning: Caution regarding the use of windshield wipers in “ AUTO” mode (vehicles with rain-sensing windshield wipers) The windshield wipers may operate unexpectedly if the sensor is touched or the windshield is subject to vibration in “ AUTO” mode. Take care that your fingers or anything else does not become caught in the windshield wipers. Caution regarding the use of washer fluid When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury. Notice: When the washer fluid tank is empty Do not operate the switch continually as the washer fluid pump may overheat. When a nozzle becomes blocked In this case, contact your Toyota dealer.Do not try to clear it with a pin or other object. The nozzle will be damaged. To prevent battery discharge Do not leave the wipers on longer than necessary when the engine is off.