Gauges and meters (with 4.2-inch display) The meters display various drive information. Meter Clock Engine Tachometer Meter display The units used on the meter and display may differ depending on the target region. Tachometer Displays the engine speed in revolutions per minute Outside temperature (Outside temperature display) Clock (Adjusting the clock) Multi-information display Presents the driver with a variety of driving-related data (Multi-information display) Displays warning messages if a malfunction occurs (If a warning message is displayed) Speedometer Displays the vehicle speed Fuel gauge Displays the quantity of fuel remaining in the tank Odometer and trip meter Odometer: Displays the total distance that the vehicle has been driven Trip meter: Displays the distance the vehicle has been driven since the meter was last reset. Trip meters “A” and “B” can be used to record and display different distances independently. Shift position and shift range indicator Displays the selected shift position or selected shift range (Automatic transmission) Engine coolant temperature gauge Displays the engine coolant temperature Note: The meters and display illuminate when The engine switch is in ON. Outside temperature displayOutside temperature display In the following situations, the correct outside temperature may not be displayed, or the display may take longer than normal to change. When stopped, or driving at low speeds (less than 12 mph [20 km/h]) When the outside temperature has changed suddenly (at the entrance/exit of a garage, tunnel, etc.) When “ --” or “ E” is displayed, the system may be malfunctioning.Take your vehicle to your Toyota dealer. Displays the outside temperature within the range of -40°F (-40°C) to 122°F (50°C). When the outside temperature is approximately 37°F (3°C) or lower, the indicator will flash for approximately 10 seconds, then stay on. Liquid crystal display Liquid crystal display Warning: The information display at low temperatures Allow the interior of the vehicle to warm up before using the liquid crystal information display. At extremely low temperatures, the display monitor may respond slowly, and display changes may be delayed. For example, there is a lag between the driver’s shifting and the new gear number appearing on the display. This lag could cause the driver to downshift again, causing rapid and excessive engine braking and possibly an accident resulting in death or injury. Notice: To prevent damage to the engine and its components Do not let the indicator needle of the tachometer enter the red zone, which indicates the maximum engine speed. The engine may be overheating if the engine coolant temperature gauge is in the red zone (“ H”). In this case, immediately stop the vehicle in a safe place, and check the engine after it has cooled completely. (If your vehicle overheats) Switches “ODO TRIP”switch Odometer and trip meter display “ODO TRIP” switch “ODO TRIP”switchUsing the “ODO TRIP” switch Switches the items of the odometer, trip meter A and trip meter B by pressing the “ODO TRIP” switch. When the trip meter is displayed, pressing and holding the switch will reset the trip meter. Meter Instrument panel light control Instrument panel light control Brightness control Instrument panel light control Instrument panel light control The brightness of the instrument panel lights can be adjusted by turning the dial. Brighter Darker Note: Instrument cluster brightness adjustment The instrument cluster brightness levels when the tail lights are on and off can be adjusted individually. However, when the surroundings are bright (daytime, etc.), turning on the tail lights will not change the instrument cluster brightness. ClockAdjusting the clock The clocks can be adjusted on the audio system screen. Vehicles with Entune Audio Clock settings Vehicles with Entune Audio Plus or Entune Premium Audio Refer to “ NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL”.