Light bulbs You may replace the following bulbs by yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer. For more information about replacing other light bulbs, contact your Toyota dealer. Preparing for light bulb replacement Check the wattage of the light bulb to be replaced. (Light bulbs) Bulb locations Front Front turn signal lights/parking lights (bulb type) Replacing the following lights If any of the lights listed below has burnt out, have it replaced by your Toyota dealer. Headlights Daytime running lights Front turn signal lights/parking lights (LED type) Front side marker lights Front fog lights (if equipped) Side turn signal lights Stop lights/rear turn signal lights Tail lights Back-up lights Rear side marker lights High mounted stoplight License plate lights Outer foot lights (if equipped) Note: Lights Replacing light bulbs Headlights Replacing light bulbs Parking lights Replacing light bulbs Daytime running lights Replacing light bulbs Turn signal lights Replacing light bulbs Front turn signal lights Replacing light bulbs Side marker lights Replacing light bulbs Front side marker light Replacing light bulbs Front fog lights Replacing light bulbs Side turn signal lights Replacing light bulbs Stop lights Replacing light bulbs Tail lights Replacing light bulbs Back-up lights Replacing light bulbs Rear turn signal lights Replacing light bulbs Rear side marker lights Replacing light bulbs High mounted stoplight Replacing light bulbs License plate lights Replacing light bulbs Outer foot lights Replacing light bulbs LED Lights The lights other than the front turn signal lights/parking lights (bulb type) each consist of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. Condensation build-up on the inside of the lens Temporary condensation build-up on the inside of the lens of any lights does not indicate a malfunction. Contact your Toyota dealer for more information in the following situations: Large drops of water have built up on the inside of the lens of any light. Water has built up inside of any lights. When replacing light bulbs When replacing light bulbs Replacing light bulbs Front turn signal lights Replacing light bulbs Front turn signal lights/parking lights (bulb type) Turn the bulb base counterclockwise and remove it. Remove the light bulb. Install a new light bulb and then install the bulb base to the light unit by inserting it and turning it clockwise. After installing the bulb base, wiggle it lightly to make sure it is securely installed and turn the lights on to visually check that there is no light leaking from between the bulb base and light unit. Warning: To prevent injury Before performing any light bulb replacement procedure, be sure to turn the power switch off. Failure to do so may result in burns from hot components or a part of your body may get caught on an operating component, possibly causing serious injury. Replacing light bulbs Turn off the lights. Do not attempt to replace the bulb immediately after turning off the lights.The bulbs become very hot and may cause burns. Do not touch the glass portion of the light bulb with bare hands. When it is unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid getting moisture and oils on the bulb.Also, if the bulb is scratched or dropped, it may blow out or crack. Fully install light bulbs and any parts used to secure them. Failure to do so may result in heat damage, fire, or water entering the headlight unit. This may damage the headlights or cause condensation to build up on the lens. Do not attempt to repair or disassemble the light bulbs, connectors, electric circuits or component parts.Doing so may result in death or serious injury due to electric shock. To prevent damage or fire Make sure bulbs are fully seated and locked. Check the wattage of the bulb before installing to prevent heat damage.