If a warning message is displayed The multi-information display shows warnings for system malfunctions and incorrectly performed operations, and messages that indicate a need for maintenance. When a message is displayed, perform the appropriate corrective action for the message. If a warning message is displayed again after the appropriate actions have been performed, contact your Toyota dealer. Additionally, if a warning light comes on or flashes at the same time that a warning message is displayed, take the appropriate corrective action for the warning light. (If a warning light turns on or a warning buzzer sounds) Note: Warning messages The warning messages explained below may differ from the actual messages according to operation conditions and vehicle specifications. Warning buzzer A buzzer may sound when a message is displayed. The buzzer may not be audible if the vehicle is in a noisy location or if the audio system volume is high. If “Engine Oil Level Low Add or Replace” is displayed The engine oil level is low. Check the level of the engine oil, and add if necessary. This message may appear if the vehicle is stopped on a slope. Move the vehicle to a level surface and check to see if the message disappears. If “Hybrid System Stopped Steering Power Low” is displayed This message is displayed if the hybrid system is stopped while driving. When steering wheel operations are heavier than usual, grip the steering wheel firmly and operate it using more force than usual. If “Hybrid system overheated Output power reduced” is displayed This message may be displayed when driving under severe operating conditions. (For example, when driving up a long steep hill.) Handling method: If your vehicle overheats If “Traction battery needs to be protected. Refrain from the use of N position.” is displayed This message may be displayed when the shift lever is in N. As the hybrid battery (traction battery) cannot be charged when the shift lever is in N, shift the shift lever to P when the vehicle is stopped. If “Traction battery needs to be protected. Shift into P to restart.” is displayed This message is displayed when the hybrid battery (traction battery) charge has become extremely low because the shift lever has been left in N for a certain amount of time. When operating the vehicle, shift to P and restart the hybrid system. If “Shift is in N Release accelerator before shifting” is displayed The accelerator pedal has been depressed when the shift lever is in N. Release the accelerator pedal and shift the shift lever to D or R. If “Press brake when vehicle is stopped Hybrid system may overheat” is displayed The message may be displayed when the accelerator pedal is depressed to hold the vehicle while the vehicle is stopped on an incline, etc. The hybrid system may overheat. Release the accelerator pedal and depress the brake pedal. If “Auto power off to conserve battery” is displayed Power was cut off due to the automatic power off function. Next time when starting the hybrid system, operate the hybrid system for approximately 5 minutes to recharge the 12-volt battery. If “Headlight System Malfunction Visit Your Dealer” is displayed The following systems may be malfunctioning. Have the vehicle inspected by your Toyota dealer immediately. The LED headlight system AFS (Adaptive Front-lighting System) (if equipped) The automatic headlight leveling system (if equipped) Automatic High Beam If “AWD System Malfunction 2WD Mode Engaged Visit Your Dealer” or “AWD System Overheated Switching to 2WD Mode” is displayed This message may be displayed when driving under extremely high load conditions. Drive the vehicle at low speeds and stop the vehicle in a safe place with the hybrid system operating until the message is cleared. If the message is not cleared, have the vehicle inspected by your Toyota dealer. If “System Malfunction Visit Your Dealer” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) (if equipped) BSM (Blind Spot Monitor) (if equipped) RCTA (Rear Cross Traffic Alert) (if equipped) Safe Exit Assist (if equipped) Intuitive parking assist (if equipped) PKSB (Parking Support Brake) (if equipped) Have the vehicle inspected by your Toyota dealer immediately. If a message that indicates the need for visiting your Toyota dealer is displayed The system or part shown on the multi-information display is malfunctioning. Have the vehicle inspected by your Toyota dealer immediately. If “System Stopped See Owner's Manual” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision System) LDA (Lane Departure Alert) LTA (Lane Tracing Assist) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) (if equipped) BSM (Blind Spot Monitor) (if equipped) RCTA (Rear Cross Traffic Alert) (if equipped) Safe Exit Assist (if equipped) Intuitive parking assist (if equipped) PKSB (Parking Support Brake) (if equipped) Follow the following correction methods. Check the voltage of the 12-volt battery Check the sensors that the Toyota Safety System 3.0 uses for foreign matter covering them. Remove them if any. (Toyota Safety Sense 3.0) Remove any dirt or foreign matter from the rear side radar sensors Close the back door Indicates the sensors may not be operating properly. (Toyota Safety Sense 3.0) When problems are solved and the sensors are operational, this indication may disappear by itself. If “System Stopped Front Camera Low Visibility See Owner’s Manual” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision system) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) (if equipped) Follow the following correction methods. Using the windshield wipers, remove the dirt or foreign matter from the windshield. Using the air conditioning system, defog the windshield. Close the hood, remove any stickers,etc. to clear the obstruction infront of the front camera. If “System Stopped Front Camera Out of Temperature Range Wait until Normal Temperature” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision system) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) AHB (Automatic High Beam) Dynamic radar cruise control RSA (Road Sign Assist) (if equipped) Follow the following correction methods. If the front camera is hot, such as after the vehicle is parked in the sun, use the air conditioning system to decrease the temperature around the front camera If a sunshade was used when the vehicle was parked, depending on its type, the sunlight reflected from the surface of the sunshade may cause the temperature of the front camera to become excessively high If the front camera is cold, such after the vehicle is parked in an extremely cold environment, use the air conditioning system to increase the temperature around the front camera If “System Stopped Front Radar Sensor Blocked Clean Radar Sensor” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision system) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) AHB (Automatic High Beam) Dynamic radar cruise control Follow the following correction methods. Check if there is any foreign matter attached to the radar sensor or radar sensor cover and clean them if necessary (Toyota Safety Sense 3.0) This message may be displayed when driving in an open area with few nearby vehicles or structures, such as a desert, grasslands, suburbs, etc. The message may be cleared by driving the vehicle in an area with structures, vehicles, etc., nearby. If “System Stopped Front Radar Sensor Out of Temperature Range Wait until Normal Temperature” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision system) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) AHB (Automatic High Beam) Dynamic radar cruise control The temperature of the radar sensoris outside of the operating range. Wait for the temperature to become appropriate. If “System Stopped Front Radar In Self Calibration See Owner’s Manual” is displayed Indicates one of the following systems is disabled. PCS (Pre-Collision system) LTA (Lane Tracing Assist) LDA (Lane Departure Alert) AHB (Automatic High Beam) Dynamic radar cruise control Follow the following correction methods. Check if there is any foreign matter attached to the radar sensor or radar sensor cover and clean them if necessary (Toyota Safety Sense 3.0) The radar sensor may be misaligned and will be adjusted automatically while driving. Continue driving for a while. If “Cruise Control Unavailable See Owner's Manual” is displayed Indicates one of the following systems is disabled. Dynamic radar cruise control Cruise control A message is displayed when the driving assist switch is pushed repeatedly. Press the driving assist switch quickly and firmly. If “Maintenance Required Soon” is displayed Indicates that all maintenance according to the driven distance on the maintenance schedule^* should be performed soon. Comes on approximately 4500 miles (7200 km) after the message has been reset. If necessary, perform maintenance. Please reset the message after the maintenance is performed. (Maintenance data (fuel, oil level, etc.)) ^*Refer to the separate “Scheduled Maintenance” or “Owner’s Manual Supplement” for the maintenance interval applicable to your vehicle. If “” is displayed Indicates that all maintenance is required to correspond to the driven distance on the maintenance schedule^*. Comes on approximately 5000 miles (8000 km) after the message has been reset. (The indicator will not work properly unless the message has been reset.) Perform the necessary maintenance. Please reset the message after the maintenance is performed. (Maintenance data (fuel, oil level, etc.)) ^*Refer to the separate “Scheduled Maintenance” or “Owner’s Manual Supplement” for the maintenance interval applicable to your vehicle. If a message that indicates the need for referring to Owner’s Manual is displayed If “Engine Coolant Temp High” is displayed, follow the instructions accordingly. (If your vehicle overheats) If any of the following messages are displayed on the multi-information display, it may indicate a malfunction. Have the vehicle inspected by your Toyota dealer immediately. “Smart Key System malfunction” “Hybrid System Malfunction” “Check Engine” “Hybrid Battery System Malfunction” “Accelerator System Malfunction” If any of the following messages are displayed on the multi-information display, it may indicate a malfunction. Immediately stop the vehicle and contact your Toyota dealer. “Braking Power Low” “Charging System Malfunction” “Oil Pressure Low” If any of the following messages are shown on the multi-information display, the vehicle may have run out of fuel. Stop the vehicle in a safe place and, if the fuel level is low, refuel the vehicle. (Hybrid system precautions) “Hybrid System Stopped” “Engine Stopped” If “Maintenance Required for Traction Battery Cooling Parts See Owner's Manual” is shown, the filters may be clogged, the air intake vent may be blocked, or there may be a gap in the duct. Therefore, perform the following correction procedure. Cleaning the hybrid battery (traction battery) air intake vents. (Cleaning the hybrid battery (traction battery) air intake vent)If the warning message is shown even if the vents are cleaned, have the vehicle inspected by your Toyota dealer. Notice: If “High Power Consumption Power to Climate Temporarily Limited” is displayed frequently There is a possible malfunction relating to the charging system or the 12-volt battery may be deteriorating. Have the vehicle inspected by your Toyota dealer.