Light bulbs You may replace the following bulbs by yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer. For more information about replacing other light bulbs, contact your Toyota dealer. Preparing for light bulb replacement Check the wattage of the light bulb to be replaced. (Light bulbs) Bulb location Rear turn signal lights Back-up lights License plate lights Lights that need to be replaced by your Toyota dealer Headlights Daytime running lights Front turn signal/parking lights Front side marker lights Side turn signal lights Tail lights Stop lights Fog lights (if equipped) Rear side marker lights High mounted stoplight Outer foot lights (if equipped) Note: LED lights The lights other than the following lights each consist of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. Rear turn signal lights Back-up lights License plate lights Condensation build-up on the inside of the lens Temporary condensation build-up on the inside of the light lens does not indicate a malfunction. Contact your Toyota dealer for more information in the following situations: Large drops of water have built up on the inside of the lens. Water has built up inside the light. When replacing light bulbs When replacing light bulbs Replacing light bulb Rear turn signal lights Open the back door. Remove the securing screws and remove the unit. Remove the lamp assembly by pulling it directly backward from the rear of the vehicle. Turn the bulb base counterclockwise. Remove the light bulb. Install a new light bulb. Install the bulb base to the light unit by inserting it and turning the bulb base clockwise. Align the grooves on the light unit with the claws, and insert the light unit straight so that the pin on the light unit fit into the hole. Confirm that the light unit is completely secured. Reinstall the screws. Back-up lights Open the back door and remove the cover. To prevent damage to the cover, wrap the tip of the screwdriver with a rag, etc. Turn the bulb base counterclockwise. Remove the light bulb. Install a new light bulb. Install the bulb base to the light unit by inserting it and turning the bulb base clockwise. Reinstall the cover. License plate lights Remove the cover. Using a flathead screwdriver, remove the cover. To prevent damage to the vehicle, wrap the tip of the flathead screwdriver with tape, etc. Remove the lens. Lens Hook Insert a small flathead screwdriver, etc. into either the right or left hole of the lens. Push the screwdriver sideways in the direction of the arrow shown in the illustration, disengage the hook, and then remove the lens. To prevent damage to the vehicle, wrap the tip of the screwdriver with tape, etc. Remove the light bulb. Install a new light bulb. Install the lens. Hooks Fit the lens into either the right or left hooks. Push the lens into place. After installation, confirm that the lens is properly installed by gently pulling it. Install the cover. Warning: Replacing light bulb Turn off the light. Do not attempt to replace the bulb immediately after turning off the light. The bulb becomes very hot and may cause burns. Do not touch the glass portion of the light bulb with bare hands. When it is unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid getting moisture and oils on the bulb. Also, if the bulb is scratched or dropped, it may blow out or crack. Fully install light bulb and any parts used to secure it. Failure to do so may result in heat damage, fire, or water entering the light unit. This may damage the light or cause condensation to build up on the lens. Do not attempt to repair or disassemble light bulbs, connectors, electric circuits or component parts.Doing so may result in death or serious injury due to electric shock. To prevent damage or fire Make sure bulb is fully seated and locked. Check the wattage of the bulb before installing to prevent heat damage.