Other interior features

USB charging portUSB charging port (if equipped)

The USB charging port are used to supply 3.0 A of electricity at 5 V to external devices.The USB charging port are for charging only. They are not designed for data transfer or other purposes.Depending on the external device, it may not charge properly. Refer to the manual included with the device before using a USB charging port.

Using the USB charging port

Front

Lift the lid while pulling up the knob.

Rear (if equipped)

Note:

The USB charging port can be used when

The engine switch is in ACC or ON.

Situations in which the USB charging port may not operate correctly

If a device which consumes more than 3.0 A at 5 V is connected

If a device designed to communicate with a personal computer, such as a USB memory device, is connected

If the connected external device is turned off (depending on device)

If the temperature inside the vehicle is high, such as after the vehicle has been parked in the sun

About connected external device

Depending on the connected external device, charging may occasionally be suspended and then start again. This is not a malfunction.

Notice:

To prevent damage to the USB charging port

Do not insert foreign objects into the port.

Do not spill water or other liquids into the port.

Do not apply excessive force to or impact the USB charging port.

Do not disassemble or modify the USB charging port.

To prevent damage to external devices

Do not leave external devices in the vehicle. The temperature inside the vehicle may become high, resulting in damage to an external device.

Do not push down on or apply unnecessary force to an external device or the cable of an external device while it is connected.

To prevent battery discharge

Do not use the USB charging port for a long period of time with the engine stopped.

Power outletPower outlet

The power outlet can be used for 12 V accessories that run on less than 10 A.

Lift the lid while pulling up the knob and open the power outlet lid.

Note:

The power outlet can be used when

The engine switch is in ACC or ON.

When turning the engine switch off

Disconnect electrical devices with charging functions, such as mobile battery packs.If such devices are left connected, the engine switch may not be turned off normally.

Notice:

To prevent the fuse from being blown

Do not use an accessory that uses more than 12 V 10 A.

To avoid damaging the power outlet

Close the power outlet lid when the power outlet is not in use. Foreign objects or liquids that enter the power outlet may cause a short circuit.

To prevent the battery from being discharged

Do not use the power outlet longer than necessary when the engine is not running.

Wireless chargerWireless charger (if equipped)

A portable device, such as a smartphone or mobile battery, can be charged by just placing it on the charging area, provided the device is compatible with the Qi wireless charging standard created by the Wireless Power Consortium.

The wireless charger cannot be used with a portable device that is larger than the charging area. Additionally, depending on the portable device, the wireless charger may not operate properly. Refer to the operation manual of the portable device.

The “ Qi” symbol

The “ Qi” symbol is a trademark of the Wireless Power Consortium.

Name for all parts

Power supply switch

Operation indicator light

Charge area^*

Charging tray

Portable devices and wireless chargers contain charging coils. The charging coil in the wireless charger can be moved within the charge area near the center of the charging tray. If the charging coil inside a portable device is detected in the charge area, the charging coil inside the wireless charger will move toward it and start charging. If the charging coil inside a portable device moves outside of the charge area, charging will automatically stop.If 2 or more portable devices are placed on the charging tray, their charging coils may not be properly detected and they may not be charged.

Using the wireless charger

Press the power supply switch of the wireless charger.

Pressing the switch again turns the wireless charger off.When turned on, the operation indicator light (green) comes on. When the engine switch is turned off, the on/off state of the wireless charger will be memorized.

Place a portable device on the charging area with its charging surface facing down.

While charging, the operation indicator light (orange) will be illuminated.If charging does not begin, move the portable device as close to the center of the charging area as possible.If charging is not performed, the operation indicator light will slowly illuminate in green and orange alternatively and a sound of charging coil operation may be heard repeatedly. Depending on the portable device, its charging coil may not be in the center of the device. In this case, place the portable device so that its charging coil is centered in the charging area.When charging is complete, the operation indicator light (green) will illuminate.

Recharging function

If a certain amount of time has elapsed since charging completed and the portable device has not been moved, the wireless charger will restart charging.

If a portable device is moved significantly within the charging area, the charging coil may disconnect and charging may temporarily be stopped. However, if a charging coil is detected within the charging area, the charging coil inside the wireless charger will move near the other coil and charging will resume.

Operation indicator light status


Operation indicator light	State
Off	The Wireless charger is off
Green (illuminated)	Standby (charging is possible)
Green (illuminated)	Charging is complete^*
Orange (illuminated)	A portable device has been placed on the charging area (identifying the portable device)
Orange (illuminated)	Charging in progress

Depending on the portable device, the operation indicator light may stay illuminated (orange) after charging has completed.

If the operation indicator light blinks

If an error is detected, the operation indicator light will blink (orange). Take the appropriate measures according to the table below.


Operation indicator light	Suspected cause	Measure
Blinks (orange) at a one second interval continuously	Vehicle to charger communication failure.	If the engine is running, stop and then restart the engine.If the engine switch is in ACC, start the engine.
Blinks (orange) 3 times repeatedly	A foreign object exists between the portable device and charging area.	Remove the foreign object.
Blinks (orange) 3 times repeatedly	Portable device is not positioned properly on the charging area.	If there is a case or cover attached to the portable device, remove it.
Blinks (orange) 4 times repeatedly	The temperature of the wireless charger is excessively high.	Stop charging, remove the portable device from the charging tray, wait for the temperature to drop, and then start charging again.

Note:

The wireless charger can be operated when

The engine switch is in ACC or ON.

Portable devices that can be charged

Portable devices compatible with the Qi wireless charging standard can be charged by the wireless charger. However, compatibility with all devices which meet the Qi wireless charging standard is not guaranteed.

The wireless charger is designed to supply low power electricity (5 W or less) to a cellular phone, smartphone, or other portable device.

If a cover or accessory is attached to the portable device

Do not charge a portable device if a cover or accessory which is not Qi compatible is attached. Depending on the type of cover (including for certain genuine manufacture parts) and/or accessory attached, it may not be possible to charge the portable device. If the portable device is placed on the charging area and does not charge, remove the cover and/or accessories.

If interference is heard in AM radio broadcasts while charging

Turn off the wireless charger and check if the noise is reduced. If noise is reduced, press and hold the power supply switch of the wireless charger for 2 seconds. The frequency of the wireless charger is changed and noise may be reduced. When the frequency is changed, the operation indicator light will blink (orange) 2 times.

Charging precautions

If the electronic key cannot be detected in the cabin, charging cannot be performed. When a door is opened and closed, charging may be temporarily suspended.

While charging, the wireless charger and the portable device will become warm. This is not a malfunction.If a portable device becomes warm while charging and charging stops due to the protection function of the portable device, wait until the portable device cools down and charge it again.

Sound generated during operation

When the power supply switch is turned on or while a portable device is being identified, operation sounds may be heard. This is not a malfunction.

Cleaning the wireless charger

Cleaning and protecting the vehicle interior

Warning:

Caution while driving

When charging a portable device, for safety reasons, the driver should not operate the main part of the portable device while driving.

Caution while in motion

Do not charge lightweight devices such as wireless headphones while in motion. These devices are very light and may be ejected from the charging tray, which may lead to unforeseen accidents.

Caution regarding interference with electronic devices

People with implantable cardiac pacemakers, cardiac resynchronization therapy pacemakers or implantable cardioverter defibrillators, as well as any other electrical medical device, should consult their physician about the usage of the wireless charger.

To prevent damage or burns

Observe the following precautions. Failure to do so may result in a equipment failure and damage, catch fire, burns due to overheat or electric shock.

Do not insert any metallic objects between the charge area and the portable device while charging

Do not attach an aluminum sticker or other metallic object to the charge area.

Do not attach an aluminum sticker or other metallic object to the side of the portable device (or to its case or cover) that touches the charge area.

Do not use the charging tray as a small storage space.

Do not subject to a strong force or impact.

Do not disassemble, modify or remove.

Do not charge devices other than specified portable devices.

Keep away from magnetic items.

Do not charge devices if the charge area is covered in dust.

Do not cover with a cloth or similar material.

Notice:

Situations in which the function may not operate normally

Devices may not be charged normally in the following situations.

The portable device is fully charged

The portable device is being charged with a cable connected

There is foreign matter between the charge area and portable device

Charging has caused the portable device to heat up

The temperature around the charging tray is 95°F (35°C) or higher, such as in extreme heat

The portable device is placed with its charging side facing up

The portable device is placed in an area misaligned from the charge area

The portable device is larger than the charging tray

A foldable and portable device is placed outside the charge area

The camera lens protrudes 0.12 in (3 mm) or more from the surface of the portable device

The vehicle is in an area where strong electrical waves or noise are emitted, such as near a television tower, power plant, gasoline station, broadcasting station, large display, airport, etc.

Any of the following objects that is 0.08 in (2 mm) or thicker is between the charging side of the portable device and the charge area

Thick cases or covers

A case or cover attached with an uneven or tilted surface, so that the charging side is not flat

Thick decorations

Accessories, such as finger rings, straps, etc.

When the portable device is in contact with, or is covered by any of the following metallic objects:

A card that has metal on it, such as aluminum foil, etc.

A pack of cigarettes that includes aluminum foil

A wallet or bag that is made of metal

Coins

A heating pad

CDs, DVDs or other media

A metal accessory

A case or cover made of metal

A case which has magnet in it on the charging side of the portable device.

Electric wave type wireless remote controls are being used nearby

2 or more portable devices are placed on the charging tray at the same time

If charging is abnormal or the operation indicator light continues to flash for any other reason, the wireless charger may be malfunctioning. Contact your Toyota dealer.

To prevent malfunctions and data corruptions

When charging, bringing a credit, or other magnetic card, or magnetic storage media close to the charge area may clear any stored data due to magnetic influence. Also, do not bring a wristwatch or other precision instrument close to the charge area since doing so may cause it to malfunction.

Do not charge with a non-contact IC card such as a transportation system IC card inserted between the charging side of a portable device and the charge area. The IC chip may become extremely hot and damage the portable device or IC card. Be especially careful not to charge a portable device inside a case or cover with a non-contact IC card attached.

Do not leave portable devices inside the vehicle. The inside of the vehicle can become hot in extreme heat, which could cause a malfunction.

If the smartphone OS has been updated

If the smartphone OS has been updated to a newer version, its charging specifications may have changed significantly. For details, check the information on the manufacturer’s website.

To prevent battery discharge

Do not use the wireless charger for a long period of time with the engine stopped.

Sun visorsSun visors

To set the visor in the forward position, flip it down.

To set the visor in the side position, flip down, unhook, and swing it to the side.

To use the side extender, place the visor in the side position, then slide it backward. (if equipped)

Vanity mirrors

Vanity lights

Mirrors Vanity mirrors

Lights Vanity lights Vanity mirrors

Slide the cover to open.

The vanity light turns on. (if equipped)

Note:

To prevent battery discharge (vehicles with vanity lights)

If the vanity lights remain on when the engine switch is OFF, the lights will go off automatically after 20 minutes.

Notice:

To prevent the battery from being discharged (vehicles with vanity lights)

Do not leave the vanity lights on for extended periods while the engine is stopped.

ArmrestArmrest (if equipped)

Fold down the armrest for use.

Notice:

To prevent damage to the armrest

Do not apply too much load on the armrest.

Assist gripsAssist grips

An assist grip installed on the ceiling can be used to support your body while sitting on the seat.

Warning:

Assist grip

Do not use the assist grip when getting in or out of the vehicle or rising from your seat.

Notice:

To prevent damage to the assist grip

Do not hang any heavy object or put a heavy load on the assist grip.

Hooks Coat hooks

Coat hooksCoat hooks

The coat hooks are provided with the rear assist grips.

Warning:

Items that cannot be hung on the coat hook

Do not hang coat hangers or other hard or sharp objects on the hook. If the SRS curtain shield airbags deploy, these items may become projectiles, causing death or serious injury.